Installation Guide

1. Measure and cut the corner moldings to length.
2. Dry fit the corner molding.
Fumes Hazard
The fumes from the silicone and
solvents used by the installer can be
harmful if used in an unventilated room. Always work in a
well-ventilated area. To keep the area well-ventilated,
open windows and use exhaust fans. If adequate
ventilation is not achievable or practical, use respiratory
protective equipment.
3. Clean the surface of the panels and the back of the
molding with denatured alcohol or another non-oil
based solvent.
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the
panel from adhering properly to the wall.
4. Apply a 1/8 to 1/4” bead of silicone to the back of
the corner molding in an S pattern, as shown.
5. Press the corner moldings into place. Remove any
excess silicone.
IMPORTANT NOTICE
WARNING
The Swan Corporation – Swanstone 20 800-325-7008
Installation Procedure