Technical Guide

SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [e-mail]
19
Installation
4.4 Mounting the BDA
Mount the GuardianA as follows:
• Verify that the selected location meets all criteria described in the previous chapter.
• Mount a 24 inch x 24 inch x 3⁄4 inch thick sheet of plywood on top of sheetrock, secured into wall studs where the NEMA
housing is to be placed. The plywood should be flush against wall.
• Once the plywood is secure, attach the NEMA housing to the plywood base using the screws provided. In most
installations, the housing will be oriented so the I/O ports are facing down.
• Connect the outdoor antenna cable to the signal booster connector port marked OUTSIDE and tighten the connection.
• Connect the outdoor antenna cable to the signal booster connector port marked INSIDE and tighten the connection.
CAUTION: DO NOT POWER ON THE BDA UNTIL INSTRUCTED
TO DO SO.
CAUTION: NEVER POWER ON THE BDA WHEN ANY ANTENNAS
ARE DISCONNECTED AS THIS COULD DAMAGE THE BDA.
Installation
CHAPTER 5: CONFIGURATION & TESTING
5.1 Powering on the BDA
1. Make sure the exterior and interior antenna cables are firmly connected to their corresponding ports on the NEMA-4 enclosure.
2. Plug a surge suppressor into a grounded 110VAC wall outlet.
3. Plug the AC end of the power adapter (supplied with your BDA) into the surge suppressor.
4. Plug the DC end of the power adapter into the Power port on the NEMA enclosure.
5. Verify that the green Power light is illuminated.
6. When the booster is turned on, the band lights will flash red and yellow for approximately 10 seconds.
CAUTION: ONLY USE THE POWER SUPPLY INCLUDED WITH THE
BDA. USE OF ANOTHER POWER SUPPLY COULD DAMAGE THE
BDA AND/OR POWER SUPPLY.
CAUTION: DO NOT PROCEED BEYOND THIS POINT UNTIL THE
BDA IS POWERED ON AND NO RED WARNING LIGHTS ARE
ILLUMINATED.