Installation Guide

ManualsBrandsSurebonder ManualsKitchenPneumatic 1/4 in. x 18-Gauge Crown 1-9/16 in. Staple Gun with Carrying Case

FPC Corporation - 355 Hollow Hill Drive - Wauconda, IL 60084

Phone: (847) 487- 4583 Fax: (847) 487-0174

website: www.surebonder.com e-mail: sales@surebonder.com

1211

Operating Instructions

Read Safety Rules and Instructions Carefully;

Save this manual for Future Reference

Model 9630 Pneumatic Stapler

5/8" thru 1-9/16”

SUREBONDER

Uses

and most 18 gauge 1/4" crown staples

Heavy Duty Staples

1/4"

Crown

Series

350

Gauge

WARRANTY

If you have any problems with this tool, please call FPC

Corporation toll-free at 1-800-860-3838 before returning it to

the place of purchase.

FPC Corporation warrants this tool to be free from defects in material and

workmanship, under normal conditions of use and when used in

accordance with FPC operating instructions, for a period of 90 days from

the date of purchase by the user. Within the 90 days warranty FPC at its

option shall repair or replace tool. The stapler must be returned at the

distributor/user expense, either within warranty or out. Repaired or

replaced tools will receive a 60 day warranty. USER MUST BE USING

THE PROPER STAPLES FOR THIS WARRANTY TO BE VALID. WARRANTY

IS VOID IF INCORRECT TYPE OF STAPLES ARE USED.

Visit us at surebonder.com for our full line of products

Summary of content (4 pages)

PAGE 1
® Model 9630 Pneumatic Stapler WARRANTY If you have any problems with this tool, please call FPC Corporation toll-free at 1-800-860-3838 before returning it to the place of purchase. FPC Corporation warrants this tool to be free from defects in material and workmanship, under normal conditions of use and when used in accordance with FPC operating instructions, for a period of 90 days from the date of purchase by the user. Within the 90 days warranty FPC at its option shall repair or replace tool.
PAGE 2
IMPORTANT SAFETY WARNINGS THE SAFETY WARNINGS BELOW CANNOT COVER ALL POSSIBLE SITUATIONS THAT MAY OCCUR. THESE BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO PROTECT AGAINST PERSONAL INJURY TO THE OPERATOR OR OTHER PERSONNEL IN THE AREA, AS WELL AS DAMAGE TO THE EQUIPMENT. READ AND UNDERSTAND THESE WARNINGS BEFORE USING EQUIPMENT. Keep tool away from children, and DO NOT allow children near work area. Do not allow children or untrained personnel to handle this tool.
PAGE 3
Preparing for Use APPLICATIONS If the stapler has been stored in a cold environment, bring it to a warm area and allow it to warm up before using. Important: Keep lubricator filled with pneumatic oil after each use or after using 3-4 strips of staples. Including, but not limited to: Furniture, Underlayment, Paneling, Molding trim, Soffits, and general staple use. FEATURES Loading - Make sure stapler is disconnected from air supply.
PAGE 4
DO NOT place finger on trigger when disconnecting air hose - the stapler could fire when reconnected to the air supply. Carry tool by the handle only, not by the air hose. Do not drive staples close to the edge of the workpiece. It could split, allowing a staple to fly or ricochet and causing personal injury. Do not try to drive staples at too steep an angle. Make sure stapler is held firmly during firing to minimize recoil.