Sonoma P L AT I N U M EDITION TM Sonoma Platinum Edition Grill: 30” Model USE AND CARE MANUAL FOR OUTDOOR USE ONLY MADE IN THE U.S.A.
General Safety Instructions IMPORTANT SAFETY INFORMATION - Read this manual carefully before using your grill to reduce the risk of fire, burn hazard or other injury. - Extreme care should be used because of the high temperatures produced by this appliance. CHILDREN SHOULD NOT BE LEFT UNATTENDED IN AN AREA WHERE THE GRILL IS BEING OPERATED. - This appliance must be kept clear from combustible materials, gasoline or other flammable vapors and liquids.
Grill Features: SGR30LP 7 1 8 2 9 12 3 13 4 10 5 14 11 6 1. Roll top grill hood 8. Warming shelf 2. Grilling/Cooking surface 9. Infrared back burner 3. Side Shelf 10. Electronic igniter: main, rear infrared & side burner 4. Control knob: back infrared burner 11. Cart with door 5. Control knobs: main burners 12. Side Burner 6. Convection vents 13. Control knob: Side Burner 7. Hood Handle 14.
Grill Assembly IMPORTANT: Remove all protective plastic film from stainless steel parts prior to assembly/use. This film is installed at the factory to prevent damage that could occur during shipment and handling. Fig. 1 SIDE SHELF ATTACHMENT 1. Attach the shelf to the left side of grill by inserting the shelf hooks into the slots on the side of the grill and pushing down on the shelf assembly until level with grill. (See Fig. 1) 2. Lock the shelf in place by tightening the four (4) bolts under the shelf.
Side Burner Assembly SIDE BURNER PARTS ASSEMBLY 1. Remove burner assembly from packaging. (See Fig. 7) 2. Loosen the bolts on the side of the grill and attach the shelf by allowing the bolt heads to fall through the large openings in the bottom of the keyhole slots. Slide the shelves downward until the bolts are resting against the top of the key hole slots. Tighten the (4) shelf bolts. (See Fig. 8-9) 3.
Side Burner Assembly SIDE BURNER PARTS ASSEMBLY 6. Install black plastic knob. (See Fig. 14 ) Fig. 14 7. Install burner and cap. (See Fig. 15-16) 8. Install grate over burner. (See Fig. 17) 9. Attach the three (3) wires coming out from the side of the grill and the side burner wire to the igniter terminals. (See Fig. 18-19) NOTE: It does not matter which wire goes to which terminal on the igniter. Fig. 15 IGNITER ASSEMBLY: (SEE FIG. 20-21) 1.
Gas Requirements L.P. GAS INSTALLATION Sonoma Gas Grills are set to operate with L.P. gas and come with a high capacity hose and regulator assembly. (Note: Only use the pressure regulator and hose assembly supplied with the grill or a replacement pressure regulator and hose assemblies specified by Sonoma). This assembly is designed to connect directly to a standard 20 lb. L.P. cylinder. L.P. Cylinders are not included with the grill. L.P. Cylinders can be purchased separately at an independent dealer.
Pre Operation Leak Testing GENERAL INFORMATION Although all gas connections on the grill are leak tested prior to shipment, a complete gas tightness check must be performed at the installation site due to possible shifting during shipment, installation or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks and immediately check the system if the smell of gas is detected. BEFORE TESTING Do not smoke while leak testing. Extinguish all open flames.
Lighting the Grill Do not attempt to “Light” the grill if the odor of gas is present!! BEFORE LIGHTING Important! Before Lighting... Check the gas supply line for cuts, wear or abrasion. Fig. 23 Always keep your face and body as far away from the grill as possible when lighting. GRILL BURNER LIGHTING Lighting the Grill with electronic igniter 1. Make sure tall control knobs are in the “OFF” position. 2. Open the gas supply valve located on top of your L.P. tank. ATTENTION: When turning the L.P.
Using the Grill GRILL LOCATION Do not use the grill in garages, breezeways, sheds or any enclosed area. Never operate the grill in enclosed areas as this could lead to a carbon monoxide buildup, which could result in injury or death. Place the grill on a level surface. Avoid moving the grill while it is operation. NOTE: The grill will operate best if it is not facing directly into the wind.
Using the Rotisserie & Side Burners The grill rotisserie system is designed to cook items from the back using infrared heat. The rotisserie burner is an infrared type which provides intense searing radiant heat. Preferred by chefs over other cooking methods, this intense heat sears in the natural juices and nutrients found in quality cuts of meats. ! Remove the warming rack from the grill when using the rotisserie to prevent warping from the intense heat of the infrared unit.
Using the Rotisserie & Side Burners ROTISSERIE LIGHTING Open the lid. Push and turn the control knob for the rotisserie counter clockwise to the “HIGH” position. Wait 5 seconds. Then press and hold the electronic igniter button. You’ll hear a snapping sound. If the burner does not light in 4 seconds, turn the control knob to OFF and wait 5 minutes before trying again. Once lit, turn the control knob to the desired setting. (See Fig.
Care and Maintenance DRIP TRAY The drip tray should be cleaned periodically to prevent heavy buildup of debris. NOTE: Allow the drip tray to cool before attempting to clean. Important: Do not leave the grill outside during inclement weather unless it is covered. Rain water can collect inside of the grill, the grill cart or the drip tray if left uncovered.
Troubleshooting Your Grill GENERAL TROUBLE SHOOTING You should inspect the burners at least once a year or immediately if any of the following conditions occur: • The smell of gas. • Flames appearing mostly yellow. (some yellow at the tips is OK) • The grill will not get hot enough. • Burners make a snapping noise. • The grill heats unevenly. SPIDER AND INSECT WARNING Spider and insects can nest in the burners of this or any other grill and cause the gas to flow from the front of the burner.
Troubleshooting Your Grill PROBLEM SOLUTION Grill will not light with a match or low heat with dial set to "High" position. • Is your gas supply fully turned on? • Is there gas in your L.P. tank ? Check your gas level. • Shut off gas supply, disconnect gas line at tank, reconnect the line to the tank. • Make sure all the knobs are in the off position, then open the gas supply valve on the L.P. tank very slowly 1/4 turn, then open fully (at least two full turns). Check flame height again.
Warranty LIMITED LIFETIME WARRANTY Sonoma warrants this grill to the original purchaser of our grills when subject to normal residential use to be free from defects in workmanship and materials for the periods listed below. IMPORTANT: We recommend you return the warranty registration card so that you can be contacted with any questions of safety arise that could affect you. The return of the warranty registration card is not a condition for warranty coverage.