Instructions / Assembly

Mats Inc. | 179 Campanelli Parkway, Stoughton, MA 02072 | 1-800-MATS-INC
AFTER THE INSTALL: FULL SPREAD
• Try to stay off new vinyl floor for 24 hours. If you must walk on the floor, avoid the
seams.
• To allow the adhesives to setup properly, keep the room at 68° F or greater for at least
2 days.
• Ventilate the area well for 48 to 72 hours.
• Light foot traffic is allowed after 24 hours.
• Don't wet mop your floor for about five days. The adhesives need time to cure.
• Most of all follow the instructions on the adhesive label.
AFTER THE INSTALL: FLOATING METHOD
• Foot traffic is fine immediately following installation.
FURNITURE AND APPLIANCE PLACEMENT
• Don't rely on furniture or appliance wheels and do not drag appliances over your new
floor!
• Lay down a piece of thin plywood and move the appliance over the floor on the wood,
or use furniture sliders made specifically for this purpose.
NOTES
• Although our products are colorfast, avoid exposure to direct sunlight for
prolonged periods. Exposure may result in discoloration. During peak sunlight
hours, the use of the drapes or blinds is recommended
• Supreme Garage Floor Tile is water/moisture resistant, however, excessive
moisture in the subfloor could promote mold, mildew, and other moisture related
issues like the trapping of moisture emissions under the flooring, which may
contribute to an unhealthy indoor environment.
• Supreme Garage Floor Tile does not warrant nor is responsible for damage to floor
covering due to moisture related issues.
• You may test for excessive moisture by duct taping a 12" x 12" clear plastic square
to the floor before installation. After 48 hours, check the plastic. A light foggy
appearance is normal; droplets of water or dense foggy plastic is excessive.
• We also recommend keeping some leftover pieces of vinyl for future repairs "just
in case