INSTALLATION INSTRUCTIONS FARMHOUSE FIRECLAY KITCHEN SINK
CAUTION: Risk of personal injury or product damage. Handle with care. Product can break, chip, cause injury or product damage. CAUTION WARNING: This product can expose you to chemicals, including lead, which is known to the state of California to cause cancer and birth defects or other reproductive harm. For more information go to p65warnings.ca.gov IMPORTANT INFORMATION Read these instructions carefully before you begin this installation. Observe all applicable local plumbing and building codes.
RECOMMENDED TOOLS □ Tape Measure □ Shims or Cabinet Fillers □ Safety Glasses □ Denatured Alcohol □ Painter’s Tape □ Clamps □ Level □ Construction Adhesive □ Ear Protection □ Silicone Adhesive Sealant □ Hacksaw/Jigsaw □ Support Framing Material (1 ¼” (32mm) Max Thickness) □ Pencil (Not permanent marker) □ Screws (recommended by countertop manufacturer) FIRECLAY SINK INSTALLATION INSTRUCTIONS STEP1: BASE CABINET PREPARATION Outline for Apron Front Sink Cutout Measure the size of the sink, incl
STEP3: CABINET/SUPOORT FRAME CONSTRUCTION Support Strips Support Board This step is to ensure that the bottom of the sink has enough support. Construct a wood support frame to fit inside the cabinet opening. Allow adequate clearance for the water supply lines and drainage system. The recommended support frame design is shown in the illustration on the left, which consists of four vertical supporting strips, two horizontal supporting strips and one supporting board.
STEP5: COUNTERTOP INSTALLATION Apply Silicone Sealant After Cleaning the Sink Edge and Countertop Apply Silicone Sealant Where the Sink Meets the Countertop and Cabinet After cleaning, apply a bead of silicone sealant between the top flange (or lip) of the sink and the countertop to create a watertight seal. Clean excess silicone immediately. Verify the overall appearance and check for levelness to ensure correct drainage. Carefully place the countertop and verify that it is level.
