Instructions / Assembly

Do not tighten hardware until all components have been loosely assembled.
If the hardware is tightened too soon, mounting holes may not align, and parts may not easily t together.
IMPORTANT: Lock nuts must be installed with the nylon insert facing outward.
Page 2 / 5LW-DUCL 10/2020
ASSEMBLY
STEP 1 A: 1 H: 1


release handle on Bed (A), ensuring the ends of the
handle go through the holes on the end of the bottom
frame.
Align the two holes of Rear Axle Support (E) with the
inside edge of Bed (A), ensuring the single hole of
the support is on the outside of Bottom Frame (H).
Secure the axle to the bed using 2x Hex Bolt (Q), 2x
Washer (Y), and 2x Lock Nut (T).
Repeat this step on the opposite side.
STEP 2 E: 2 Q: 2 Y: 2 T: 2
STEP 3 N: 1
Run Rear Axle (N) through the rear axle supports and
bottom frame.
Place Front Axle Brace (L) on the front section [behind
the release handle] of Bottom Frame (H). Secure by
hand-tightening 2x Hex Bolt (Q), 2x Washer (Y), and
2x Lock Nut (T).
STEP 4 L: 1 Q: 2 Y: 2 T: 2