SDS

Page 5/10
Safety Data Sheet
Regulation (EC) No. 1907/2006 and 1272/2008
Printing date 09.01.2018 Revision: 08.01.2018Version number 1
Trade name: NI-MH RECHARGEABLE BATTERY
(Contd. of page 4)
46.0.9
1310-73-2 sodium hydroxide (2.8%)
WEL (Great Britain) Short-term value: 2 mg/m³
MAK (Germany) vgl.Abschn.IIb
VME (France) Long-term value: 2 mg/m³
7782-42-5 Graphite (2.6%)
AGW (Germany) Long-term value: 1.25* 10** mg/m³
2(II);*alveolengängig**einatembar; AGS, DFG
VME (France) Long-term value: 2 mg/m³
pour la fraction alvéolaire
·
Regulatory information
WEL (Great Britain): EH40/2011
VME (France): ED 984, 10.2016
MAK (Germany): MAK- und BAT-Liste
AGW (Germany): TRGS 900
·
DNELs:
Not available
·
PNECs:
Not available
·
Additional information:
The lists valid during the making were used as basis.
·
8.2 Exposure controls
Based on the composition shown in Section 3, the following measures are suggested for occupational safety
measure.
·
Appropriate engineering controls:
Keep away from foodstuffs, beverages and feed.
Immediately remove all soiled and contaminated clothing
Wash hands before breaks and at the end of work.
Store protective clothing separately.
Avoid contact with the eyes.
Avoid contact with the eyes and skin.
See Section 7 for information about design of technical facilities.
·
Personal protective equipment
·
Respiratory protection:
In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure
use self-contained respiratory protective device.
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
·
Penetration time of glove material:
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be
observed.
(Contd. on page 6)
EU