Instructions / Assembly

ManualsBrandsSunnydaze Decor ManualsFountainsSoothing Matrix Indoor Tabletop Water Fountain with LED Light

TROUBLESHOOTING

• Ensure the pump is fully submerged under water. Add water to the

basin as necessary.

• Check to make sure the power outlet is working; if in doubt about

electrical connections, consult a certified electrician.

• Check the pump and tubing for obstructions.

• Check the flow control on the body of the pump as it may need to be

adjusted to achieve the desired flow rate.

• If the light is not working, ensure the cables are fully connected and the

seal is adequately tightened (do not over-tighten).

• If water is not flowing within several moments of the fountain being

plugged in, unplug the power supply for a few moments and plug it

back in. The pump may have air bubbles in the filter, which can prevent

water from circulating properly.

USE & CARE

• For indoor use only.

• Keep fountain out of reach of children and pets.

• Keep power cord away from all heat sources. Do not place electrical

cords in areas with high temperatures.

• Check the water level frequently to ensure the pump remains fully

submerged; never allow the pump to run dry as it will burn out the motor.

• Only use water in this fountain; distilled water is recommended to

prevent mineral buildup.

• Periodically change the water to keep the water, fountain and pump

clean. Remove scale and buildup regularly.

DO NOT use harmful additives such as bleach, chlorine, etc.

DO NOT use anything abrasive to scrub the fountain.

• Always shut off the power supply before cleaning and maintaining the

fountain and the recirculating pump.

• Take care when handling the pump; only pick it up by the body of the

pump, never the power cord.

IMPORTANT INFORMATION

Any modication to the product or failure to follow

recommended care will void the product warranty.

NOTE: The water tubing is built into the fountain. Take care when handling the water tube; detaching the

water tube from the fountain will damage the fountain and void the product warranty.

ASSEMBLY:

1. Connect the shorter cable on the pump to the LED light cord that is inside

the fountain. If the cords are already connected, check connection and

tighten the plastic collar. Connect the pump to the water tube and place

the pump inside the fountain.

2. Run pump power cable out the back of the fountain. Align the cable with

the groove in the access panel cover, as shown.

3. Twist the access panel cover to secure it to the back of the fountain.

4. Fill the fountain with enough water to keep the pump fully submerged

during operation, approximately 8 cups.

5. Place the mesh screen over the basin, and the glass ball on top of the fountain.

6. Connect the AC adapter to the power cord and plug it into a properly

grounded GFCI outlet.

Note: When rst used, there may be air in the pump.

It may take several minutes for trapped air to escape, allowing water to ow.