ASSEMBLY INSTRUCTIONS Item: L-GZ224PAL-1 Hardware Pack 1 60 pieces (AA) 1/4＂-20*0.6 Bolt 32 pieces (BB) 1/4＂-20*1.2 Bolt 8 pieces (CC) 1/4＂-20*1.4 Bolt 8 pieces (II) 1/4＂-20*1.
Parts List Top connector A 1 Long beam with small roof bar B 4 Short oblique beam C 4 Long oblique beam D 4 Top long beam E 4 Top short beam F 4 Oblique beam connector G 4 Long round pole H 4 Short round pole I 4 Long support beam J 4 Short support beam K 4 Column L 4 Support triangle M 8 Column base N 4 Base cover O 4 Small canopy P 1 Big canopy Q 1 Mosquito netting R 1 Wall S 1
Step1 J K M H I M K H M Fig.5 J M J I Fig.4 Fig.3 K M L K J Fig.2 M M M L L N(O) L N(O) N(O) N(O) Fig.1 Fig.2 L AA K DD O AA K J AA DD N DD DD AA J J(K) L Fig.1 Fig.5 Fig.4 Fig.3 J K M DD BB L I H DD AA Step1 1. Slide base cover (O) onto column (L), connect column base (N) to column (L) using bolt (AA), flat washer (DD) and tighten. (Fig.1) Repeat for each column. 2.
Fig.12 Step2 A F E K H M B J I Fig.6 E J K D F H I E Fig.14 F E Fig.8 F J Fig.13 G K M K Fig.7 Fig.9 Fig.10 Fig.11 M C J L N(O) Fig.8 F E EE DD DD II Fig.9 E AA DD F Fig.10 G F E EE DD CC DD G DD EE C DD II Fig.12 A D Fig.13 B AA D B Fig.11 D B DD C Fig.
Step2 6. Connect top short beam (F), long support beam (J), top long beam (E) and short support beam (K) using bolt (AA), flat washer (DD), and assemble all corners before tightening. (Fig.6) Repeat on all sides. 7. Connect top short beam (F), top long beam (E) and long support beam (J), using bolt (AA) and flat washer (DD), assemble all corners before tightening. (Fig.7) Repeat on all sides. 8.
Step3 15. Cover roof with big canopy (Q), do not fully extend. (Fig.15) 16. Cover top with small canopy (P). (Fig.16) 17. Hang mosquito netting (R) onto long round pole (H) and short round pole (I), using mosquito netting hooks (HH)). (Fig.17) 18. Hang wall (S) onto top long beam (E) and top short beam (F), using mosquito netting hooks (HH). (Fig.18). Then finish stretching big canopy (Q). 19. Anchor column base (N) to ground using stake (GG), and then cover the column base with base cover. (Fig.
Exclusions: Items used for commercial, contract, or other non-residential purposes, or items damaged due to acts of nature, vandalism, misuse, or improper assembly are not covered. Corrosion or rusting of hardware is not covered. Proof of purchase (dated register receipt) is required for warranty claims. Warranty is to the original purchaser and is non-transferable.
