Owner's Manual

9
8. Fit the stainless steel lance into the trigger gun and rotate
the collar until the two parts are completely locked (Fig. 9).
9. Connect the high-pressure hose to the trigger gun
(Fig. 10).
10. Connect the high-pressure hose to the water outlet on the
washer (Fig. 11).
mWARNING! Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
11. Connect the garden hose adapter (female coupler) to
the water inlet of the pressure washer, then thread your
garden hose (male end) into the garden hose adapter
(Fig. 12). The garden hose must have an internal diameter
of at least 13 mm (1/2 in.) and must be reinforced. The
water supply must be at least equal to the washer delivery
capacity.
NOTE: The machine is not suitable for connection to the
potable water main.
mWARNING! The machine is not suitable for connection
to the potable water main.
12. Attach garden hose to water supply (Fig. 13).
mWARNING! The intake water temperature must not
exceed 104ºF/40ºC. The water supply must not exceed
0.7 MPa.
mCAUTION! The washer must only be used with clean
water; use of unltered water containing corrosive chemicals
will damage the washer.
13. Make sure the On/O switch is set to the OFF (0) position
before plugging the unit into the power outlet (Fig. 14).
Fig. 9
Stainless
steel lance
Trigger gun
Collar
High-pressure hose
Trigger gun
Fig. 10
Fig. 11
High-pressure water outlet
(REAR)
High-pressure
hose
Fig. 12
Water inlet
(female coupler)
Garden hose
This end to
water inlet
Garden hose
(male end)
Fig. 13
Connect to water supply
Garden hose