Instruction Manual

ManualsBrandsSunex Tools ManualsToolsSX223

SX223 1 Rev. 04/24/03

Operating Instructions • Warning Information • Parts Breakdown

SX223

3/8" DR.

EVERSIBLE

IR DRILL

Free Speed ..................1,800 RPM

Maximum Capacity ................3/8”

Air Inlet ..........................1/4” NPT

Hose Size ..........................3/8” ID

Air Pressure ........................90 PSI

Air Consumption..................4 CFM

Length ..................................7.60”

Shipping Weight..............2.42 Lbs.

Some dust created by power sanding, sawing, grinding, drilling,

and other construction activities contains chemicals known to

cause cancer, birth defects or other reproductive harm. Some

examples of these chemicals are:

• lead from lead-based paints,

•crystalline silica from bricks and cement

and other masonry products, and

• arsenic and chromium from

chemically-treated lumber.

Your risk from these exposures varies, depending on how often

you do this type of work. To reduce your exposure to these

chemicals: work in a well ventilated area, and work with

approved safety equipment, such as those dust masks that are

specially designed to filter out microscopic particles.

ALWAYS READ

INSTRUCTIONS

BEFORE USING

POWER TOOLS

ALWAYS WEAR

SAFETY GOGGLES

WEAR HEARING

PROTECTION

AVOID

PROLONGED

EXPOSURE TO

VIBRATION

SPECIFICATIONS

Summary of content (4 pages)

PAGE 1
Operating Instructions • Warning Information • Parts Breakdown Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm.
PAGE 2
! WARNING! ▲ FAILURE TO OBSERVE THESE WARNINGS COULD RESULT IN INJURY. and arms. Discontinue use of tool if discomfort, tingling feeling or pain occurs. Seek medical advice before resuming use. This Instruction Manual Contains Important Safety Information. Read THIS INSTRUCTION MANUAL Carefully and understand ALL INFORMATION Before Operating THIS Tool. • Place the tool on the work before starting the tool. Do not point or indulge in any horseplay with this tool.
PAGE 3
Operating Instructions • Warning Information • Parts Breakdown Operation… Locate center of new hole by using a center punch. Place drill bit tip in punch mark. Hold drill square with work and start motor. Apply steady, even pressure. Do not force. Too much pressure can cause bit to break or overheat. Too little pressure will keep bit from cutting and cause it to overheat. Reduce pressure just before bit cuts through the work.
PAGE 4
SX223 3/8" Dr. Reversible Air Drill Ref. # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 SX223 Item # RS13001 RS13002 RS13003 RS13004 RS13005 RS13006 RS13007 RS13008 RS13009 RS13010 RS13011 RS13012 RS13013 RS13014 RS13015 RS13016 RS21114 DESCRIPTION Housing O-Ring O-Ring Valve Stem O-Ring Bushing O-Ring Reverse Lever Spring Trigger Screw Pin Muffler Cover Screw Air Inlet Rear Gasket Bearing QTY 1 1 1 1 1 1 1 1 1 1 1 1 1 2 1 1 2 Ref.