Installation Guide

8
4. Fit the spray wand assembly into the gun and turn the
rotatable end-piece of the wand until the two parts are
completely locked (Fig. 4).
5. Connect the quick-connect end of the high-pressure hose
to the trigger gun (Fig. 5). You will hear a click when it
snaps into place. To release the high-pressure hose from
the trigger gun, push the release button on the trigger gun.
6. Connect the other end of the high-pressure hose to
the water outlet on the pressure washer (Fig. 6). First,
push the high-pressure hose end completely onto the
high-pressure water outlet, then screw it on clockwise.
mWARNING! Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
7. Connect the garden hose adapter (female coupler) to the
water inlet of the pressure washer, then thread your garden
hose (male end) into the garden hose adapter (Fig. 7). The
garden hose must have an internal diameter of at least
13 mm (1/2 in.) and must be reinforced. The water supply
must be at least equal to the washer delivery capacity.
NOTE: The machine is not suitable for connection to
the potable water main.
8. Attach garden hose to water supply (Fig. 8).
mWARNING! Do not connect to portable water system.
mWARNING! If connection is made to a portable water
system, the system shall be protected against backow
mWARNING! The intake water temperature must
not exceed 104ºF/40ºC. The water supply must not
exceed 0.7 MPa.
mCAUTION! The washer must only be used with clean
water; use of unltered water containing corrosive chemicals
will damage the washer.
RELEASE
Spray wand assembly
Trigger gun
Fig. 4
RELEASE
Push to release
Trigger gun
Fig. 5
High-pressure hose
Fig. 6
(BACK)
High-pressure
water outlet
High-pressure hose
Fig. 7
(FRONT)
Water inlet
Garden hose
This end to
water inlet
Garden hose
(male end)
Fig. 8
Connect to water supply
Garden hose