Use and Care Manual

6
Unpacking
Carton Contents
• Electric garden vacuum + blower + mulcher motor head
• Blower/vacuum chute
• Collection bag
• Screw knobs (2)
• Manual with registration card
1. Carefully remove the electric blower + vacuum + mulcher
and check to see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you nd damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use the electric blower +
vacuum + mulcher. The packaging is made of recyclable
materials. Properly dispose of these materials in
accordance with local regulations.
IMPORTANT! The equipment and packaging material are not
toys. Do not let children play with plastic bags, foils or small
parts. These items can be swallowed and pose a suocation
risk!
Assembly
m
WARNING! To avoid serious personal injury, read and
understand all safety instructions provided.
mWARNING! Do not connect to power supply until
assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
mWARNING! Before performing any maintenance, make
sure the tool is unplugged from the power supply. Failure to
heed this warning could result in serious personal injury.
mWARNING! To prevent serious personal injury, make
sure the switch is in the OFF position, the unit is unplugged
and the impeller has come to a complete stop before attaching
or removing the collection bag.
1. On the motor head assembly, press the handle pivoting
button, at the same time, adjust the handle up until it
locks into the working position (Fig. 1).
2. Insert the motor head into the blower/vacuum chute.
Press rmly to secure (Fig. 2).
3. Secure the motor head to the blower/vacuum chute using
the two screw knobs. Tighten the knobs to ensure secure
t (Fig. 3).
4. To attach the collection bag, align the two collection bag
feet into the notches on the bottom of the unit body, and
insert the collection handle tab into the locking slot under
the collection bag release button, and connect to the unit
body, as shown (Fig. 4).
Fig. 1
Handle pivoting button
Pivoting
handle
STORAGE MODE
WORKING MODE
Motor head
Fig. 2
Motor head
Blower/vacuum chute
Fig. 3
Fix with two
screw knobs