WINE CELLAR Models SWC525L & SWC525LBI CM405M421BL Owner's Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Write the Serial Number here: _________________________ FELIX STORCH, INC. 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
IMPORTANT SAFEGUARDS Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. This symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words ”DANGER” or “WARNING”.
Use two or more people to move and install the wine cellar. Failure to do so can result in back or other injury. To ensure proper ventilation for your appliance, the front of the unit must be completely unobstructed. Choose a well-ventilated area with temperatures above 60°F (16°C) and below 90°F (32°C). This unit must be installed in an area protected from the elements, such as wind, rain, water spray or drips. The wine cellar should not be located next to ovens, grills or other sources of high heat.
Table of Contents Important Safeguards ......................................................................................................... 1 - 2 Location of Parts ..................................................................................................................... 3 Technical Information .............................................................................................................. 4 Installation Instructions ..............................................................
Technical Information Model Installation SWC525L SWC525LBI Free-standing Built-in Black with glass door Color 42 standard wine bottles Capacity 115V AC / 60Hz Electrical Input Temperature Range 45°F - 65°F (7°C - 18°C) R134a, 1.59 oz. Refrigerant Unit weight Unit Dimensions (W x D x H) 66.0 lbs. 20.0" x 23¼" x 33¼" 20.0" x 23¼" x 33¼" to 34½" Installation Instructions Before Using Your Wine Cellar: Remove the exterior and interior packing.
Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extremely cold ambient temperatures may also affect the unit's performance. Avoid locating the unit in moist areas. Plug the unit into an exclusive, properly installed and grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord.
Reversing the Door Swing: Figure 1 (Default position) Figure 2 (After door reversal) 1. Upper hinge cover 2. Screws 3. Upper hinge 4. Door 5. Lower door hinge 6. Screws 7. Hole cover 8. Cabinet 9. Pin cap This wine cellar can be opened from either the right side or the left. By default, the door hinge is on the right side. If you prefer it on the left, please follow these instructions: NOTE: All of the parts that are removed must be kept for the reinstallation of the door. 1.
Operating Your Wine Cellar Setting the Temperature Control: You can adjust the temperature by pressing the ADJUST (SET) switch. Each press increases the temperature setting by 1° (either °F or °C). The temperature range is 45° to 65°F (7°C to 18°C). The default temperature is 45°F (7°C).
Care and Maintenance Cleaning your wine cellar: 1. Unplug the wine cellar and remove all items, including shelves and racks. 2. Wash the inside surfaces with a solution of warm water and baking soda. The solution should contain about 2 tablespoons of baking soda to a quart of water. 3. Wash the shelves and racks with a mild detergent solution. 4. Wash the outside cabinet with warm water and mild liquid detergent. 5. Rinse well and wipe dry with a clean soft cloth. 6.
Problems with Your Wine Cellar? You can easily solve many common problems with your wine cellar, saving you the cost of a possible service call. Try the suggestions below to see if you can correct the problem before calling the service provider. TROUBLESHOOTING GUIDE Problem Possible Cause Unit does not operate. Not plugged in. The circuit breaker has tripped or the fuse has blown. Unit is not cold enough. Check the temperature control setting. External environment may require a higher setting.
Notes 10
Limited Warranty ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory-specified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
