Support

11
Drain Hose Connection
There are several ways to insert the drain hose into the drain hose connector of the sink, as shown
in the following figures. You much connect the drain hose in accordance with the water pipe
installation regulations in your region.
Without disposal:
With disposal:
1. Check the size of the sink's drain hose connector. If needed, cut the drain hose so its end
fits onto the sink connector (5/8 in., 3/4 in. or 1 in. - as shown in C below). If the end of the
drain hose does not fi t onto the drain hose connector of the sink, use an adaptor
purchasable at a plumbing/hardware supply store.
2. Slide a hose clamp over the end of the drain hose. Attach the drain hose to the sink
connector, slide the hose clamp to the end of the hose, and then tighten the hose clamp.
NOTE: You must use a hose clamp. Failure to do so may cause water leakage.