BUILT-IN REFRIGERATOR Models: SPR623OS SPR623OSCSS Owner’s Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Write Serial Number here: _______________________ Felix Storch, Inc. An ISO 9001:2015 registered company Summit Appliance Division 770 Garrison Avenue Bronx, NY 10474 www.summitappliance.
TABLE OF CONTENTS Important Safety Instructions ............................................................................... 3 – 4 Installation Instructions ........................................................................................ 5 – 6 Before using your appliance ............................................................................... 5 Installation of your appliance .............................................................................. 5 Reversing the door swing .........
IMPORTANT SAFETY INSTRUCTIONS WARNINGTo reduce the risk of fire, electrical shock, or injury when using your appliance, follow these basic precautions Read all instructions before using the appliance: ⚫ Plug into a grounded 3-prong outlet. Do not remove the grounding prong, do not use an adapter, and do not use an extension cord. ⚫ It is recommended that a separate circuit, serving only your appliance, be provided. Use an electrical outlet that cannot be turned off by a switch or pull chain.
⚫ This appliance needs to be leveled for it to work properly. You may need to make several adjustments to level it. ⚫ Although the unit has been tested at the factory, due to transit and storage, you should clean the appliance before use. ⚫ Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may damage or discolor the interior. ⚫ Do not use this apparatus for other than residential purposes.
CALIFORNIA CARB/SNAP DISCLOSURE This product uses eco-friendly hydrocarbon refrigerant and fully complies with California CARB regulations. However, we are required by California Law to provide the following disclosure statement in every product sold in California. "This equipment is prohibited from use in California with any refrigerants on the 'List of Prohibited Substances' for that specific end-use, in accordance with California Code of Regulations, title 17, section 95374.
INSTALLATION INSTRUCTIONS Before Using Your Appliance ⚫ Remove the exterior and interior packing. ⚫ Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. ⚫ Clean the interior surface with lukewarm water using a soft cloth. ⚫ Install the handle, stored inside the unit. Install using the supplied screws.
Reversing the Door Swing This unit can have its door open from the left or right. The default option is to open from the left, but if you want to reverse the direction of the door, please follow the instructions below: To make the reversal, look inside the appliance to find the top left hinge and bottom left hinge. The bottom support bracket is used when the door opens from either side. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. Carefully lay the appliance on its back.
OPERATION The Controls of Your Appliance This appliance should be placed somewhere where the ambient temperature is between 16-35°C (60.8 - 95°F). If the ambient temperature is above or below this range, the performance of the unit may be affected. Placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate. Control Panel Setting the temperature Control ⚫ Adjustable temperature: 2°C to 8°C (35.6°F to 46.
ECO mode: • Press and hold the button for 3 seconds to enter or exit ECO mode. • In this mode, the interior LED light, the compressor indicator and the temperature value on the display panel will be turned off and the ° symbol will be illuminated in the upper left corner when the temperature is being displayed. • LED lamp brightness mode: with Memory IC (when the unit restarts after power failure unit, it will auto recover to the last setting), the default brightness is 100%.
NOTE: • If the unit is unplugged or turned off, or if there has been a power failure, you must wait 5 minutes before restarting the unit. If you attempt to restart before this time delay, the appliance will not start. • When you use the appliance for the first time or restart it after it has been shut off for a long time, there could be a few degrees variance between the temperature you select and the one indicated on the display. This is normal due to the length of inactivity.
CARE AND MAINTENANCE Cleaning Your Appliance 1. Turn off the power, unplug the appliance, and remove all items including shelves and racks. 2. Wash the inside surfaces with a warm water and baking soda solution. The solution should consist of about 2 tablespoons of baking soda to a quart of water. 3. Wash the shelves with a mild detergent solution. 4. Wring excess water out of the sponge or cloth when cleaning the area of the controls or any electrical parts. 5.
PROBLEMS WITH YOUR APPLIANCE You can solve many common problems easily, saving you the cost of a service call. Try the suggestions below to see if you can solve the problem before calling for service. TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE • The unit defrosts automatically in Appliance does not operate. • • Appliance enough. is not cold • • • • normal operating conditions. The appliance is turned off. Tripped circuit breaker or a blown fuse. The temperature is not set correctly.
NOTES 13
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, the warrantor will pay for factory specified parts and repair labor to correct defects in materials or workmanship. A designated service company must provide service. Outside the 48 states, all parts are warranted for one year from manufacturing defects.
