Design Guide

92 | Sub-Zero Customer Care 800.222.7820
Designer Series Undercounter Refrigeration
Custom Panel
For all models, a door panel and handle must be provided.
Refer to the following charts for panel requirements and
dimensions.
Do not install a solid panel on the glass door unit. A solid
door is available as a sales accessory through an autho-
rized Sub-Zero dealer.
The panel cannot exceed the maximum panel weight indi-
cated in the chart below. The depth of each model is 23⁄"
(587). Allow for panel thickness when planning the finished
opening depth.
CAUTION
As reveals between cabinetry and the unit decrease,
severe finger pinching can occur while the door is
closing.
Finish all sides of the custom panel. They may be visible
when the door is open or through the glass of glass door
models.
A D-style handle is recommended. Locate the door handle
near the edge of the panel opposite the hinge and cen-
tered top to bottom. Stainless steel tubular and pro handles
are available through an authorized Sub-Zero dealer. For
local dealer information, visit the find a showroom section
of our website, subzero.com.
PANEL REQUIREMENTS
Panel Weight 22 lb (10 kg) max
Panel Thickness ⁄" (16) min–⁄" (19) max
Stainless Steel Panels
Stainless steel panels and handles are available through
an authorized Sub-Zero dealer. For local dealer informa-
tion, visit the find a showroom section of our website,
subzero.com.
The depth of each model is 23⁄"
(587). Allow for panel
thickness when planning the finished opening depth.