Installation Guide

HomeDepot.com

Please contact 1-877-527-0313 for further assistance.

Operation

3 4

Adjusting the heater

Press the Heater button to set the thermostat. The replace

contains two infrared quartz heating elements.

The thermostat setting range is 82°F - 62°F or 27°C - 17°C

or always ON.

The thermostat is adjustable by 2°F or 1°C increments.

NOTE:

To change between °F and °C press and hold the

Heater button on the control panel for 3 seconds.

Push the Power button to supply power to all

functions of the replace and put the insert in a

standby mode.

Push the Power button again to turn off all functions.

1 2

Powering the replace

NOTE:

Holding the Power button on the control panel for

10 seconds will disable the heater function.

NOTE:

All previous settings are held in memory, so the

next time you power up the replace, the unit will turn on

with the same settings.

Adjusting the ame

There are 5 unique 3D ame colors that can be selected.

1: Spectrare

2: Sapphire

3: Amethyst

4: Campre

5: Midnight Fire

AU: Auto Cycle will seamlessly cycle through the above

ame colors.

00: Off

Pressing the Timer button will cycle through the timer

settings; 30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H,

8H, 9H and off.

Setting the timer

NOTE:

The control panel can be accessed at the upper-right corner of the insert.