User's Manual

34 6390-009-001 REV B www.stryker.com
Return To Table of Contents
Installation Guide
INSTALLING THE OPTIONAL WHEEL GUIDE
Optional Wheel Guide Kit Components (6390-027-000)
Ǩɣ (2) Flat Head Cap Screw (p/n 0001-195-000) Ǩɣ (2) Pan Head Machine Screw (p/n 0023-296-000)
Ǩɣ (1) Wheel Guide Assembly (p/n 6390-001-017) Ǩɣ (5) Spacer (p/n 6390-001-173)
Ǩɣ (5) Wheel Turner Support (p/n 6390-001-174) Ǩɣ (2) Wheel Kicker Rail Bumper (p/n 6390-001-175)
Ǩɣ (1) Wheel Kicker Rail (p/n 6390-001-176) Ǩɣ (1) Wheel Turner Cap (p/n 6390-001-178)
Ǩɣ (1) Wheel Turner Nut (p/n 6390-001-191) Ǩɣ (4) Wheel Cover (p/n 6390-001-206)
Tools Required:
Ǩɣ Tape Measure Ǩɣ Saw (or equivalent) Ǩɣ Pencil
Ǩɣ Drill Ǩɣ 1/4” Drill Bit Ǩɣ 7/16” Socket
Ǩɣ 3/8” Drive Ratchet Ǩɣ 7/16” Combination Wrench Ǩɣ T25 Torx Driver
Ǩɣ 5/32” Allen Wrench
Procedure:
Note: While installing the wheel guide, see
page 35 for component assembly detail.
1. Using a tape measure, measure from the center line of the floor plate to the wall (cabinet) on the driver’s side of
the vehicle patient compartment (reference Figure 27 and Figure 28).
Figure 27: Wheel Guide Installation without Spacers
Figure 28: Wheel Guide Installation with Spacers
Wall (Cabinet)
Wheel Kicker Rail
Wheel Guide Assembly
Door
Spacer
11-3/16 ”
(30 cm)
13-5/16”
(33.81 cm)
11-3/16”
(30 cm)
17-1/2”
(44.45 cm)
Wall (Cabinet)
Door
Wheel Kicker Rail
Wheel Guide Assembly