Product Manual

Page 10 of 19
2. Loosen and remove the three screws (1) on the height, adjusting base on the upper
connectingpole (2). Place the spring(4) into the standing pole(4). Insert the upper connecting pole
(2) into thestanding pole (4), making sure the holes on the height adjusting base and the standing
pole (4) arealigned. Insert the three screws (1) into the standing pole (4) and tighten them. Adjust
theheight of the upper connecting pole (2) as desired and secure using the adjusting knob.
3. Insert a bolt (5) into the hole on the neck bearing (found on the motor) and into thetop of the
upper connecting pole. Secure them together using a bushing (1) anda nut (2). Insert one bolt (6)
through the hole in the neck bearing and into the top of theupper connecting pole and secure
them using a bushing (4) and a nut (3).