Product Manual

Page 6 of 22
 Do not use a product with a malfunctioning switch. Any power tool that cannot be controlled with
the power switch is dangerous and must be repaired by an authorized service representative
before using.
 Disconnect the power/air supply from the product and place the switch in the locked or off position
before making any adjustments, changing accessories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool accidentally.
 Store the product when it is not in use. Store it in a dry, secure place out of the reach of children.
Inspect the tool for good working condition prior to storage and before re-use.
 Use only accessories that are recommended by the manufacturer for use with your product.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
Specific Operation Warnings
⚠WARNING
 To prevent serious injury or property damage, read and understand the owner’s manual before
use.
 Do not exceed the rated load capacity.
 Operate on a hard, level surface.
 Do not operate crane if the beam is not level.
 Be sure the trolley stoppers have been fixed to both ends of the beam.
 Ensure the load is centered before lifting.
 Do not use to lift people or animals.
 Keep persons and property clear from under the load.
 Do not leave loads suspended when the gantry crane is unattended.
 Do not allow the load to swing or roll against the support members.
 Inspect the crane for damaged parts and loose bolts before each use.
 Do not use the crane if there are damaged parts. Replace damaged parts before continuing use.
 Do not adjust height or disassemble crane while loaded.
 Secure trolley and hoist in the center of the beam when adjusting height.
 Do not push or pull crane with a forklift or other vehicle.
 Never push the load when trying to move the crane. Always push the crane.
 When moving crane while loaded, keep the load close as close to the floor as possible and
position the load in the center of the beam.
 Do not anchor the legs to the floor.
 Secure the trolley and hoist in the center of the beam when adjusting the height.