Product Manual

Page 5 of 11
⚠CAUTION
STORAGE RACK USE AND CARE
 Do not force the storage rack. Products are safer and do a better job when used in the manner for
which they are designed. Plan your work, and use the correct product for the job.
 Check for damaged parts before each use. Carefully check that the product will operate properly
and perform its intended function. Replace damaged or worn parts immediately. Never operate the
product with a damaged part.
 Store the storage rack when it is not in use. Store it in a dry, secure place out of the reach of
children. Inspect the tool for good working condition prior to storage and before re-use.
 Use only accessories that are recommended by the manufacturer for use with your product.
Accessories that may be suitable for one product may create a risk of injury when used with
another tool. Never use an accessory that has a lower operating speed or operating pressure than
the tool itself.
Specific Operation Warnings
⚠WARNING
 Do not lean, pull, or hang items on the storage rack. Tipping may occur resulting in personal
injury.
 Do not exceed the rated load capacity of each bin, shelf, or the storage rack as whole.
 Be sure to evenly distribute loads. Concentrating loads may cause the rack to fail, causing
property damage or personal injury.
 Do not climb on the storage rack. It may tip over causing personal injury.
 Be sure storage rack is secured to wall at all times.
 When using the back stop feature to pull out the bin and hang on the rack, do not pull out more
than one row of bins at a time. Tipping may occur, resulting in personal injury or property damage.
 Do not allow children to play on or near the storage rack.
Assembly Instructions
For easiest assembly, do not attach the TOP (B), MIDDLE (C) and BOTTOM (D) POLES until Step 5.
Once connected, these will be the posts for the storage rack. Each POLE (B+C+D) has slight
horizontal line indentations at each shelf position. Each SLIP SLEEVE (F) has raised horizontal lines
inside designed to lock them in place on the POLE (B+C+D).
STEP 1
On each BOTTOM POLE (D), place 1 pair of SLIP SLEEVES (F)
at the lowest position. BASE (E) end should be pointed down.
Make sure the arrows on SLIP SLEEVES (F) faces up and that
the word ‘TOP’ is right side up.
Slide the pair of SLIP SLEEVES (F) until you hear a click to
confirm the pair is locked onto the BOTTOM POLE (D). DO NOT
place more than one pair on each POLE at a time.
Note: There will be a very small gap in-between the SLIP
SLEEVES (F)—this is normal.