Product Manual

8
BEFORE USE
1. Before using this product, read the owner's manual completely and familiarize yourself thoroughly with the
product and the hazards associated with its improper use.
2. Perform the air purge procedure. (See previous instructions for system purge procedure.)
3. Pour a teaspoon of good quality, air tool lubricant into the air supply inlet of the lift control valve. (See
illustration) Connect to air supply and operate for 3 seconds to evenly distribute lubricant.
4. Check to ensure that jack rolls freely (if so equipped with wheels) and that the pump operates smoothly
before putting into service. Replace worn or damaged parts and assemblies with manufacturer approved
parts only.
5. This product is fitting use standard 1/4" NPT air fitting. If changing the fitting is required, install a 1/4" NPT
fitting of your choice, ensure that thread tape or compound is used to seal connection.
6. Inspect before each use. Do not use if bent, broken or cracked components are noted.
OPERATION
RAISING THE JACK
1. Block the vehicle’s wheels for lifting stability. Secure the load to prevent inadvertent shifting and movement
2. Position the jack near desired lift point.
3. Set the Parking Brake in the vehicle.
4. Refer to the vehicle manufacturer owner’s manual to locate approved lifting points on the vehicle. Position the
jack so that the saddle is centered and will contact the load lifting point firmly.
5. Assemble the handle; ensure that spring clips align with slots.