Product Manual

Page 6 of 11
STEP 2
Place a SHELF (A) on its side and slide the (4) BOTTOM
POLES (D) through the holes in the SHELF (A). Make sure that
the SHELF (A) corner cylinders are positioned over the SLIP
SLEEVES (F).
Take 2 SCREWS (G) and put them through the bottom of the
BASE (E), the side with the feet levelers, and fasten them to
BOTTOM POLES (D). Tighten the SCREWS (G) with the HEX
KEY (H).
Repeat with the other BASE (E).
STEP 3
Stand the unit upright and push each corner of the shelf until the
top of the SLIP SLEEVES (F) are flush with top of the corner
cylinders on the shelf.
Note: The level side of the SHELF (A) is the TOP side
(Strongway logo on corner cylinders should be right-side up).
Use a rubber mallet, if needed, to secure the SHELVES (A).
STEP 4
Install the next set of SLIP SLEEVES (F) on the (4) BOTTOM
POLES (D) in the next position up from the bottom. Place
another SHELF (A) over the BOTTOM POLES (D) and secure
the SHELF (A) so the top of the SLIP SLEEVES (F) are flush
with top of the corner cylinders on the SHELF (A).
Repeat until all shelf positions on the BOTTOM POLES (D) have
a SHELF (A).