Installation Guide
PAGE 6 OF 12
4\LSSLY:[YLHTSPUL*V:JOPSSPUN)S]K:\P[L*VSSPLY]PSSL;5800.348.8464^^^T\LSSLYZ[YLHTSPULJVT1HU
Installation Instructions (1/2" - 2")
Installation Instructions (2-1/2" - 4")
1. 3.2.
5.
Check fitting bead to ensure seal
is present. Do not use any type of
oil lubrication.
8.
Place press tool at a right angle
over fitting bead. Start the pressing
process. Please see specific tool
manufacturer for tool instruction.
6.
Mark tube to proper fitting inser-
tion depth (see Insertion Depth
Chart below).
7.
Turn slightly while sliding press
fitting onto tube. Slide all the way
to insertion mark & make contact
with stop.
Streamline PRS™ Fitting Insertion Depth Chart (1/2" - 2")
Tube Size 1/2" 3/4"
1" 1-1/4" 1-1/2" 2"
Insertion Depth 3/4" 7/8" 7/8" 1" 1-7/16" 1-9/16"
Streamline PRS™ fittings must be connected with approved press tool.
Please see specific tool manufacturer for tool instruction.
4.
9.
Mark joint site with an "X" once
crimping process is complete
to verify that the connection has
been pressed.
1.
Cut tube square using a tube
cutter or fine tooth saw.
3.
Deburr tube OD using half
round file.
2.
5.
Check fitting ends to ensure seal, grip
ring and nylon spacer are present. Do
not use any type of oil lubrication.
8.6. 7.
4.
Sand tube OD with sand cloth. Tube
surface should be free of indentati-
on, scratches, & deformations.
9.
Large diameter (2-1/2" – 4") Streamline PRS
TM
fittings must be connected with approved
press tool and press-rings. Please see specific
tool manufacturer for tool instruction.
Streamline PRS™ Fitting Insertion Depth Chart (2-1/2" - 4")
Tube Size 2-1/2" 3"
4"
Insertion Depth 1-3/4" 1-7/8" 2-1/8"
! WARNING
Failure to follow all instructions could affect joint/system integrity
and may lead to property damage. Call Customer Service at
1-800-FITTING if you have any questions or need assistance.
!
Cut tube square using a tube
cutter or fine tooth saw.
Mark joint site with an "X" once
crimping process is complete to
verify that the connection has
been pressed.
Deburr tube ID using a
deburring tool.
Deburr tube ID using a
deburring tool.
Mark tube to proper fitting
insertion depth (see Insertion
Depth Chart below).
Deburr tube OD using half
round file.
Turn slightly while sliding press
fitting onto tube. Slide all the way
to insertion mark & make contact
with stop.
Sand tube OD with sand cloth. Tube
surface should be free of indentation,
scratches, & deformations.
Place press-ring at a right angle
over fitting bead & check for
proper engagement. Start the
pressing process. See specific tool
manufacturer for tool instruction.