Installation Guide

Company Profile:
Surface Solutions, LLC
Industry: Surface Engineering
Consulting
Slip Resistant Treatments
Anti-Graffiti Treatments
Website:
www.totalsurfacesolution.com
Corporate Address:
515 Valley St.
Suite 130
Maplewood, NJ 07040
Contact:
[e-mail]
888-842-3356
Stonewalled™ Basic Application Instructions
Tools Required:
Spray Bottle
Cleaning Tools
Sponge
Paper Towels
Bucket of water
**Read all instructions before beginning application process.
Application Conditions
- Surface material needs to be clean and free of all foreign contaminants.
- Surface temperature needs to be greater than 40 degrees and rising and less
than 90 degrees
- For ideal application, do not allow surface to get wet / rained on for at least 24
hours after application
Application Instructions
Step 1: Mix 4oz TractionWash™ : Gallon of Water in a bucket - 1:32
Step 2: Broadcast Traction Wash mix on area to be treated and agitate with a brush. Let stand for 10 minutes to begin
to break down foreign contaminants.
Step 3: Rinse and extract dirt and cleaner from surface.
Concrete brightening - if desired.
If you desire to whiten and brighten the concrete to be treated follow step 3A
Step 3A: Mix InvisaTread™ (IVT) 1:3 - 1 part IVT : 3 parts water.
- Broadcast IVT mix onto area to be treated and brush to cover
- Let stand for 5 minutes
- Rinse with 1:20 dilution of Traction Wash™
- Pressure wash to rinse off material.
Step 4: Allow surface to thoroughly dry. use extraction and floor dryers to assist in dry time.*
*To test if surface is dry enough pour a small amount of water into a test section. Surface should darken showing that it is
able to take moisture.
Step 5: Fill spray bottle with Stonewalled™ - DO NOT DILUTE
Step 6: Spray Stonewalled™ in even smooth overlapping strokes onto surface. Use a roller to cut in areas if desired.**
- When spraying on vertical surfaces - ALWAYS spray from the bottom to the top. Never spray top
down.
- If a horizontal surface is pitched to drain, ALWAYS spray from the bottom of the slope to the top.
**Do not spray material to the point of creating puddles. Consumption should be between 175 - 225 sq. ft per
gallon.
Step 7: Allow surface to dry
Step 8: DO NOT WALK ON SURFACE FOR AT LEAST 4 HOURS, IDEALLY 12 HOURS. Full cure in 5 - 7 days***