OPERATION AND INSTALLATION AUTOMATIC HAND DRYER » GALAXY™ 1 » GALAXY™ M1 » GALAXY™ 2 » GALAXY™ M2 Certified to ANSI/UL Std. 499 Conforms to CAN/CSA Std. 22.2 No.
GENERAL INFORMATION 1. 1.1 General Information ____________________________________________________________ 2 Safety instructions _______________________________________________________________________3 2. 2.1 Safety ____________________________________________________________________________ 4 Intended use ______________________________________________________________________________4 3. Register your product __________________________________________________________ 6 4.
NOTE: Read these instructions carefully before using the appliance and keep them for future reference. Pass on the instructions to a new user if required. 1.1 Safety instructions 1.1.1 Structure of safety instructions ! KEYWORD: Type of risk Here, possible consequences are listed that may result from failure to observe the safety instructions. f Steps to prevent the risk are listed. 1.1.
SAFETY 2. Safety 2.1 Intended use The appliance is intended for drying hands. This appliance is intended for domestic use. It can be used safely by untrained persons. The appliance can also be used in a non-domestic environment, e.g. in a commercial setting, as long as it is used in the same way. Any other use beyond that described shall be deemed inappropriate. Observation of these instructions and of instructions for any accessories used is also part of the correct use of this appliance.
! ! WARNING: Injury Where children or persons with limited physical, sensory or mental capabilities are allowed to control this appliance, ensure that this will only happen under supervision or after appropriate instructions by a person responsible for their safety. Children must be supervised to ensure that they never play with the appliance. WARNING: Fire Never operate this appliance...
REGISTER YOUR PRODUCT 3. Register your product You must register this product within 90 days of purchase on our website in order to activate the standard warranty or to be eligible for the extended warranty. Go to our web site at www.stiebel-eltron-usa.com and click on register your product.
CLEANING, CARE AND MAINTENANCE Cleaning, care and maintenance ! MATERIAL LOSSES: The Galaxy™ hand dryer does not contain any parts serviceable by nonlicensed people. In case of malfuntion please contact a licensed electrician. To clean the case use a soft cloth with a mild detergent if necessary. Never use any abrasive cleaners since they will scratch the finish of the unit. Never spray water or cleaning fluids directly on hand dryer.
3 2 1 89” (2250 mm) m) 0 600 24” ( 0 1 2 3 118” 24” (600 m (3000 mm) MINIMUM CLEARANCES ) mm Danger zone: do not install unit in bathtubs showers, or wash basins. Danger zone: do not install directly above bathtubs or showers. Danger zone: do not install within 24˝ (600 mm) of bathtubs or showers Safe area: unit must be installed in this area, outside of danger zones 2, 1 and 0.
min 4Ý (102 mm) 48Ý (1219 mm) Mount the hand dryer at least 48˝ (1219 mm) above the floor. 8. Preparation The Galaxy ™ hand dryer must have its own independent circuit using 3 wire cable of the appropriate size protected by a correctly rated double-pole circuit breaker. The Galaxy ™ 1 unit for 110 – 120 V requires a 20 A circuit breaker and AWG 12 copper wire. The Galaxy ™ 2 unit for 220 – 240V or 208 V requires a 15 A circuit breaker and AWG 12 copper wire.
WALL MOUNTING f Pull down the locking slide and remove the front cover. f Cut a hole in the back housing and install a ½˝ strain relief connector for the electric cable. Tighten the strain connector onto the cable. 9. Wall mounting f Drill the mounting holes in the wall. Use anchors for securing into drywall or tile. Anchoring to studs is preferred, but not required. lone für M ont a 1 f Secure the unit into the pre-drilled holes. 10 | GALAXY™ AUTOMATIC HAND DRYERS WWW.STIEBEL-ELTRON-USA.
ELECTRICAL INSTALLATION f Connect the wires to the terminal block connections. 208—240V/60Hz 110—120V/60Hz L N/L GND 1 GND N/L L 1M ~ 3 2 1 Fan motor 2 Heating element 3 Sensor f Reinstall the front cover. Push up the locking slide and reinstall the three screws that were removed. WWW.STIEBEL-ELTRON-USA.COM GALAXY™ AUTOMATIC HAND DRYERS | 11 ENGLISH 10.
SPECIFICATION 11. Specification 11.1 Dimensions Galaxy™ 1 & Galaxy™ 2 67/8Ý (175 mm) 97/8Ý (250 mm) 67/8Ý (175 mm) 91/16Ý (230 mm) Galaxy™ M1 & Galaxy™ M2 67/8Ý (175 mm) 10òÝ (266 mm) 67/8Ý (175 mm) electronic 91/16Ý (230 mm) 12 | GALAXY™ AUTOMATIC HAND DRYERS WWW.STIEBEL-ELTRON-USA.
SPECIFICATION Part number Electrical data Phase Voltage Wattage Amperage Required circuit breaker1 Required wire size2 Other Height Width Depth Weight Color Housing Sound level Air volume Drying time Part number Electrical data Phase Voltage Wattage Amperage Required circuit breaker1 Required wire size2 Other Height Width Depth Weight Color Housing Sound level Air volume Drying time Galaxy™ 1 073009 Galaxy™ M1 073724 60/50 Hz - single 120 V 1850 W 15.42 A 20 A 12 AWG 1850 W 15.
WARRANTY | ENVIRONMENT AND RECYCLINGV 12. Warranty WARRANTY Residential & Commercial Warranty: Stiebel Eltron, Inc. warrants to the original owner that the Galaxy™ touchless automatic hand dryer will be free from defects in workmanship and materials for a period of five (5) years from the date of purchase. Should the part(s) prove to be defective under normal use during this period, stiebel eltron, inc. will be responsible for replacement of the defective part(s) only. Stiebel Eltron, Inc.
ENGLISH NOTES WWW.STIEBEL-ELTRON-USA.
7 ¼ȟ Ɔ ϵͬϯϮȟ Ăůů ŵŽƵŶƟŶŐ ŚŽůĞƐ 3 ¾ȟ TĞŵƉlatĞ may not Ɖrint at ĐŽƌƌĞĐƚ ƐŝnjĞ͘ ŚĞĐŬ ůŽĐĂƟŽŶ ŽĨ ŵŽƵŶƟŶŐ ŚŽůĞƐ ĂŐĂŝŶƐƚ ŵĞĂƐƵƌĞŵĞŶƚƐ before ĚƌŝůůŝŶŐ ŚŽůĞƐ͘ 6 иȟ ½ȟ дȟ дȟ 6 ½ȟ Drilling template for mounting Galaxy™ hand dryer Ɔ ϭ Ъȟ
328505-40039-9245 United States of America STIEBEL ELTRON, Inc. 17 West Street | West Hatfield MA 01088 Tel. (413)247-3380 | Fax (413)247-3369 info@stiebel-eltron-usa.com www.stiebel-eltron-usa.
