User's Manual

USING INTERNAL MENU COMMANDS
©
©©
© RF Innovations Pty Ltd, 1998 Page: 32
234839, Revision 2.2
Idx Route Type Route Source Destination Radio
0 Single Route | Address 10 --> Dest. 9000:00
1 Single Route | Address 12 --> Dest. 9020:00
2 Single Route | Address 16 --> Dest. 9050:00
3 Mapped Route | From [ 20 to 30 ] --> Base 2000:00
4 Mapped Route | From [ 50 to 60 ] --> Base 4200:00
5 Range Route | From [ 80 to 120 ] --> Dest. 6000:00
6 Range Route | From [ 130 to 150 ] --> Dest. 7000:00
7 Default Route | All Other --> Dest. 4000:00
Press Any Key to return
Figure 6-17 Route Table Listing
(A) Add Route
When adding a route, the route type menu (Figure 6-18) is initiated. Please refer to Route Types on page
29 for a definition on the routes available.
*** Route Type Menu ***
(D) Default Route
(S) Single Route
(M) Mapped Route
(R) Range Route
(Esc) Previous Menu
Enter Choice:
Figure 6-18 Route Selection Menu
(D) Delete a Route
When this option is selected the route type menu (Figure 6-18) is brought up to select the type of route
to be deleted. Once a route type is selected all the routes of that type is listed and the IDX (route
identification number) is used to select the desired route to delete.
(L) List Route by Type
When this option is selected a route type menu (Figure 6-18) is brought up to select the type of route to
be listed. Once a route type is selected all the routes of that type is listed.
(M) HAYES COMMAND CONTROL MENU
The Hayes Command Control Menu allows the user to change Hayes compatible responses and
response codes. For example, it is here in this menu the user can toggle the echo on/off and set the
escape sequence character, etc.