Installation Guide

SP5400 Series Sliding Shower and Bath Doors
Installation Guide
Slide the notched end of the insert into the groove
and pull the notch to the end of the bottom track.
Trim the insert to be flush with the bottom track.
Center the bottom track on the ledge with the leg
to the outside. Tape the bottom track in place and
mark the position.
*Call Customer Care Center to order replacement parts.
**Finish/color code must be specified when ordering.
Retain this document for future servicing.
Record model number from box for reference.
CAUTION: Risk of injury. Do not attempt to cut
tempered glass.
IMPORTANT! Do not cut the top track the same
length as the bottom track.
Walls must be within 3/8" (10 mm) of plumb.
Cover drain with tape to avoid loss of small parts.
Follow the silicone sealant manufacturer's
instructions for application and curing time.
Installation video available at
SterlingPlumbing.com.
Parts Identification
7
89
5
2
3
4
Sliding Shower Doors
Required Tools
1
6
Model Number:______________
1204890-2-A
100% Silicone Sealant
Masking Tape
32 Teeth Per Inch Blade
Miter Box
Number 2 Pencil
3/16" 5/16"
Series Number Label
1053530
Insert
Center Guide
#8-18 x 2"
Insert
Bottom Track
Tin Snips
USA: 1-800-STERLING (1-800-783-7546)
Mexico: 001-877-680-1310
SterlingPlumbing.com
1/16"
Hardware Skin Pack
1205305**
Hanger Bracket Kit
[20" (508 mm)]
[24" (610 mm)]
Top Track
1058827-02**
Screw Cover
1031943**
Bumper
1081001
Anchor
1077762
Wall Jamb*
Gasket
1199110
Barrel Nut
1050048-B
#8-32 x 3/8"
8-32 x 1/4"
Screw
1051142-A
Roller
1044585
Hanger Bracket
1199426-01**
Sex Bolt
1077763-A
Door Panel*
1093027
Spacer (8 ea.)
1057704-02**
Towel Bar
1057704-01**
1058294**
Screw
1056868-A
Wall Jamb*
1048208-N
Screw
1203634
(SP5475-57)
(SP5465-45)
1058626-11**
Bottom Track
1058626-12**
Leg
1
Reposition both wall jambs. Secure the wall jambs
with screws. Attach a bumper at the top and
bottom locations.
Apply silicone sealant in the groove on the
underside of the bottom track. Secure the bottom
track to the ledge along the marked location.
Position the wall jambs over the bottom track.
Plumb both wall jambs. Mark the screw holes.
Remove the wall jambs. Drill 5/16” holes into the
walls and insert the anchors.
#8-18 x 2"
Groove
Screw
Cover
Screw Cover
x2
Reversible
Measure distance “B” above the wall jambs.
Subtract 1/32" (1 mm) or the width of a saw
blade from “B.” Mark and cut the top track.
Position the top track over the wall jambs. Either
side of the top track may face out.
1/32" (1 mm)
Cut Line
"B" Mark
Top Track
For both doors, slide a gasket over the top of the
glass panel and into each mounting hole. Press
the hanger bracket over the gasket and align the
hanger brackets with the mounting holes.
Hanger
Bracket
x2
Gasket
x2 x2
1
2
3
B
B