User Manual

MIDI Functions
Deleting Double Notes
Compress/Expand
Uses the Ratio setting (0 to 300 %) to compress or expand the dynamic range of
MIDI notes. A factor higher than 1 (over 100 %) expands the differences between
velocity values, while using a factor lower than 1 (under 100 %) compresses them.
● To compress the dynamic range, use ratio values below 100 %.
After compression, you can add a velocity amount to maintain the average
velocity level.
● To expand the dynamic range, use ratio values above 100 %.
Before expansion, you may can adjust the velocity to a middle of the range.
Limit
Limits the velocity values so that they stay between the Lower and the Upper values.
Deleting Double Notes
You can delete double notes of the same pitch on the exact same position from selected MIDI
parts. Double notes can occur when recording in cycle mode, after quantizing, for example.
PROCEDURE
1. Select the MIDI part that contains the double notes.
2. Select MIDI> Functions> Delete Doubles.
RESULT
The double notes are automatically deleted.
Deleting Controller Data
You can delete controller data from selected MIDI parts.
PROCEDURE
1. Select the MIDI parts that contain the controller data.
2. Select MIDI> Functions> Delete Controllers.
RESULT
The controller data is automatically deleted.
Deleting Continuous Controller Data
You can delete continuous controller data from selected MIDI parts.
PROCEDURE
1. Select the MIDI parts that contain the controller data.
2. Select MIDI> Functions> Delete Continuous Controllers.
RESULT
The continuous controller data is automatically deleted. However, On/Off events such as sustain
pedal events are kept.
693