User Manual

Table Of Contents
Automation
Editing Automation Events
The following Line tool modes are available:
Line mode
If you click on the automation track and drag with the Line tool in Line mode, you
can create automation events in a line. This is a quick way to create linear fades, etc.
Parabola mode
If you click and drag on the automation track with the Line tool in Parabola mode,
you can create more natural curves and fades.
NOTE
The result depends on the direction from which you draw the parabolic curve.
Sine, Triangle, or Square mode
If you click and drag on the automation track with the Line tool in Sine, Triangle, or
Square mode and the Snap Type is set to Grid, the period of the curve (the length
of one curve cycle) is determined by the grid setting. If you press Shift and drag, you
can set the period length manually, in multiples of the grid value.
NOTE
The Line tool can only be used for ramp type automation curves.
Editing Automation Events
Automation events can be edited much like other events.
NOTE
If you move an event or part on a track and you want the automation events to follow
automatically, select Edit> Automation Follows Events. Any automation events at the new
position are overwritten.
You can use the tools on the Project window toolbar to edit automation events.
You can use the automation event editor to edit selected automation events on ramp
automation curves.
RELATED LINKS
Toolbar on page 41
Automation Event Editor on page 606
604