User Manual

Pool
Working with the Pool
If several clips are selected, choose whether to insert them on one track or each on a
different track.
NOTE
The clips are positioned so that their snap points are aligned with the selected insert
position. If you want to adjust the snap point before inserting a clip, double-click a clip
to open the Sample Editor. Here, you can adjust the snap position and then perform the
insert options.
RESULT
The clip is inserted on the selected track or on a new audio track. If several tracks are selected,
the clip will be inserted on the first selected track.
RELATED LINKS
Adjusting the Snap Point on page 464
Inserting Clips into a Project Via Drag and Drop
You can drag a clip from the Pool into the Project window.
Snap is taken into account if Snap is activated.
If you drag the clip into the Project window, the cross-hair cursor and a tooltip are shown. The
tooltip indicates the timeline position where the snap point of the clip is aligned.
If you position the clip in an empty area of the track list, that is, where no track exists, a new track
is created for the inserted event.
NOTE
If you press and hold Shift while dragging the clip from the Pool on an event, the clip in this
event is replaced.
RELATED LINKS
Adjusting the Snap Point on page 464
Replacing Clips in Events on page 188
Cross-Hair Cursor on page 82
Deleting Clips from the Pool
You can delete clips from the Pool with or without deleting the corresponding file from the hard
disk.
Removing Clips from the Pool
PROCEDURE
1. In the Pool window, select the clips that you want to remove, and select Edit> Delete
You can also press Backspace or Delete.
2. Depending on whether the clips are used by an event, you have the following options:
●
If the clips are used by an event, click Remove and then click Remove from Pool.
●
If the clips are not used by an event, click Remove from Pool.
533