User Manual

Table Of Contents

Playback and Transport

Punch In and Punch Out

2. On the Transport panel, activate Punch In and Punch Out.

3. In the Preferences dialog, select Record.

4. Activate Stop after Automatic Punch Out.

5. On the Transport panel, activate Pre-roll and Post-roll.

6. In the Pre-roll Amount and Post-roll Amount fields, enter the pre-roll and post-roll

values.

7. Activate Record.

RESULT

The project cursor rolls back by the time specified pre-roll value and playback starts. When the

cursor reaches the left locator, recording is automatically activated. When the cursor reaches the

right locator, recording is deactivated, but playback continues for the specified post-roll value

before stopping.

Punch In and Punch Out

The punch in and the punch out points are a pair of markers that you can use for punch in and

punch out recordings. The punch in position determines the record start position whereas the

punch out position determines the record stop position.

You can activate punch in and punch out by activating the corresponding buttons on the

Transport panel.

The punch in position is locked to the left locator position and the punch out position to the right

locator position. The punch position fields are unavailable.

However, you can detach the punch points from the locators by deactivating Lock Punch Points

to Locators.

If you do so, the value fields become available and you can use them to set up the punch

positions independently from the locator positions.

You can also drag the punch in and punch out handles in the ruler to set the punch positions.