User Manual

Setting Up Your System
Setting Up Audio
About Recording Levels and Inputs
When you connect your equipment, make sure that the impedance and levels of the audio
sources and inputs are matched. Using the correct type of input is important to avoid distortion
or noisy recordings. For microphones, for example, different inputs can be used, such as
consumer line level (-10 dBV) or professional line level (+4 dBu).
Sometimes, you can adjust input characteristics on the audio interface or on its control panel. For
details, refer to the documentation that came with the audio hardware.
IMPORTANT
Cubase does not provide any input level adjustments for the signals that are coming into your
audio hardware, since these are handled differently for each card. Adjusting input levels is either
done in a special application that is included with the hardware or its control panel.
Word Clock Connections
If you are using a digital audio connection, you may also need a word clock connection between
the audio hardware and external devices. For details, refer to the documentation that came with
the audio hardware.
IMPORTANT
Set up word clock synchronization correctly, or you may experience clicks and crackles in your
recordings.
Selecting an Audio Driver
By selecting an audio driver, you allow Cubase to communicate with the audio hardware.
Normally, when you start Cubase, a dialog opens that prompts you to select a driver, but you can
also select your audio hardware driver as described below.
NOTE
On Windows operating systems, we recommend that you access your hardware via an ASIO
driver developed specifically for the hardware. If no ASIO driver is installed, contact the
manufacturer of your audio hardware for information on available ASIO drivers. If no specific
ASIO driver is available, you can use the Generic Low Latency ASIO driver.
PROCEDURE
1. Select Studio> Studio Setup.
2. In the Devices list, select VST Audio System.
3. Open the ASIO Driver pop-up menu and select your audio hardware driver.
4. Click OK.
Setting Up Audio Hardware
PREREQUISITE
You have selected a driver for your audio hardware.
PROCEDURE
1. Select Studio> Studio Setup.
2. In the Devices list, select your audio hardware driver.
12