User Manual

Recording
Monitoring
RESULT
The project cursor rolls back and starts playback at the time that has been set as pre-roll amount.
When the cursor reaches the left locator, recording is automatically activated. When the cursor
reaches the right locator, recording is deactivated, and the playback continues as long as the
time that has been set as post-roll amount.
Common Record Modes
The Common Record Modes determine what happens if you click Record during an audio or
MIDI recording.
● To access the record modes, select Transport> Common Record Modes.
You can also access the Common Record Modes by clicking the upper part of the Record
Modes section in the Transport panel.
Punch In/Out
In this mode, the recording is stopped.
Re-Record
In this mode, the recording is reinitiated, the events are removed and recording is
restarted from the exact same position.
Start Recording at Cursor
In this mode, recording starts from the cursor position.
Start Recording at Left Locator/Punch In Position
In this mode, recording starts from the left locator.
RELATED LINKS
Transport Menu on page 210
Transport Panel Sections on page 208
Re-Recording
PROCEDURE
1. Activate Transport> Common Record Modes> Re-Record.
2. Activate recording.
3. Hit Record again to restart recording.
RESULT
The project cursor jumps back to the record start position and recording is reinitiated. Pre-roll
and count-in settings are taken into account.
NOTE
The previous recordings are removed from the project and cannot be retrieved using Undo.
However, they remain in the Pool.
Monitoring
In Cubase, monitoring means listening to the input signal while preparing to record or while
recording.
The following ways of monitoring are available.
●
Via Cubase.
239