User Manual

Parts and Events
Editing Techniques for Parts and Events
2. Select the event.
3. Do one of the following:
●
Click Trim Start Left .
●
Click Trim Start Right .
●
Click Trim End Left .
●
Click Trim End Right .
RESULT
The start or end position of the selected events are moved by the amount set on the Grid Type
pop-up menu.
Resizing Events with the Scrub Tool
You can scrub the event when moving the start or end point of the event.
PROCEDURE
1. Click Play .
2. Click Play again to open a pop-up menu.
3. Select Scrub .
4. Click and drag the lower left or right corner of the event.
RESULT
The event is resized and you get an acoustic feedback while dragging.
Splitting Events
PROCEDURE
● Do one of the following:
●
Select Split and click the event that you want to split.
●
Select Object Selection , hold down Alt and click the event.
●
Move the project cursor to the position where you want to split the events, and
select Edit> Functions> Split at Cursor.
NOTE
This splits the selected events at the position of the project cursor. If no events are
selected, all events on all tracks that are intersected by the project cursor are split.
●
Set up the left and right locators at the position where you want to split the events,
and select Edit> Functions> Split Loop.
NOTE
This splits the selected events at the left and right locator positions. If no events are
selected, all events on all tracks that are intersected by the locators are split.
197