Plug-in Reference
Table Of Contents
- Table of Contents
- Included VST Audio Effect Plug-ins
- AmpSimulator
- AutoPan
- Brickwall Limiter
- Chorus
- Compressor
- Distortion
- DJ-EQ
- DualFilter
- EnvelopeShaper
- Flanger
- Gate
- Limiter
- Lin One Dither
- Maximizer
- MonoDelay
- MonoToStereo
- MorphFilter
- Octaver
- Phaser
- PingPongDelay
- REVerence
- RoomWorks SE
- Rotary
- StereoEnhancer
- SuperVision
- ToneBooster
- Tremolo
- Tube Compressor
- Vibrato
- VintageCompressor
- VST Amp Rack
- VST Bass Amp
- VSTDynamics
- WahWah
- Index
Clipping
Sets the clipping value for the Internal scale.
Minimum
Sets the minimum value for the Internal scale.
Maximum
Sets the maximum value for the Internal scale.
RMS AES17
Shows the level in accordance with AES17 (RMS +3 dB).
RMS Resolution
Sets the RMS resolution for the level display in milliseconds.
Smooth
Smoothes the display of the level curve.
NOTE
Alternatively, you can move the mouse pointer over the selected module and use the
mouse wheel to adjust this parameter.
Measurement Modules
The modules in this category allow you to measure the loudness and intelligibility of the audio
signal.
The following modules and module-specic settings are available:
Loudness
This module shows the loudness of your audio in LU (Loudness Units) or LUFS (Loudness Units
referenced to Full Scale) according to EBU R 128.
TP (True Peak)
Shows the maximum true peak level in dB.
I (Integrated)
Shows the integrated loudness value. This is the average loudness value that is
measured over the whole audio range in LU or LUFS.
S (Short-Term)
Shows the short-term loudness value that is measured every second on an audio block
of 3 seconds in LU or LUFS. This gives information about the loudest audio passages.
Included VST Audio Effect Plug-ins
SuperVision
44
Dorico 4.0.31