2.0
Table Of Contents
- Introduction
- The DSP Factory in Cubase SX/SL
- Setting up Cubase SX/SL for use with DSP Factory
- The Default Signal Routing
- Opening the DSP Factory Windows
- The Input Console window
- The Bus/Aux Console
- The Channel Overview
- The FX Editor
- The DSP Factory Output Patchbay Window
- Changing the Input Routing
- Changing the Output Routing
- Single-Track Recording
- Multi-Track Recording
- Mixing down to a Stereo Output
- Mixing down to a new Track in Cubase SX/SL
- Working with two DS2416 Cards
- Combining a DS2416 with a SW1000XG Card
- Remote Controlling the DSP Factory Mixer
CUBASE SX/SL
50
Effects
When you have two DS2416 cards installed, the Aux 3-4 Sends will
automatically be routed to the FX Unit on the Master card. All DS
channels (regardless of which card they “belong to”) can access all
four FX units.
In the FX Editor, there will be four options on the “FX Unit” pop-up
menu, labelled FX Unit 1 to 4. Aux Sends 5 and 6 are routed to FX
Unit 1 and 2 (as with one card), while Aux Sends 3 and 4 are routed
to FX Unit 3 and 4.
❐
Do not route the FX Return channels to Aux Send 3-4 – this may cause a
feedback loop.
Combining a DS2416 with a SW1000XG Card
If you have a Yamaha SW1000XG sound card installed, you can con-
nect it to the DS2416 card using the SI/SO (Serial In/Out) connec-
tions on the cards.
• Use the supplied serial cable to connect the SO output on the
SW1000XG to the SI input on the DS2416.
Follow the instructions in the documentation included with the cards.
• In the Routing window, select the “ext. SI” option in the Wordclock
section.
This will cause the DS2416 card to receive wordclock from the SW1000XG card, en-
suring stable synchronization.
Having connected the two cards, you will be able to receive 8 separate
audio channels from the SW1000XG and mix them in the DS mixer.
These 8 channels appear as the “SUB 1-8” input sources, selectable
using the Input pop-up menus for DS channels 9 to 16, or 17 to 24.