2.0
Table Of Contents
- Introduction
- The DSP Factory in Cubase SX/SL
- Setting up Cubase SX/SL for use with DSP Factory
- The Default Signal Routing
- Opening the DSP Factory Windows
- The Input Console window
- The Bus/Aux Console
- The Channel Overview
- The FX Editor
- The DSP Factory Output Patchbay Window
- Changing the Input Routing
- Changing the Output Routing
- Single-Track Recording
- Multi-Track Recording
- Mixing down to a Stereo Output
- Mixing down to a new Track in Cubase SX/SL
- Working with two DS2416 Cards
- Combining a DS2416 with a SW1000XG Card
- Remote Controlling the DSP Factory Mixer
CUBASE SX/SL
12
Physical Inputs and Outputs
By default, the physical inputs and outputs of the DSP Factory system
are connected to the DS channels in the following way:
Inputs
Outputs
“IOA” and “IOB” are the connections to additional input/output units
such as the AX44. For each DS2416 card, you can add two extra in-
put/output units (IOA and IOB). Each unit may have 4 or 8 inputs and
outputs.
❐
As you see, the default routing only provides access to four extra out-
puts (for use with external effects, etc). To be able to use all additional
inputs and outputs, you will need to re-configure the input and output
routing. This is described on page 35.
Physical Input DS Channel
DS2416 Analog In Left 17
DS2416 Analog In Right 18
DS2416 Digital In Left 19
DS2416 Digital In Right 20
Bus/Send in the DSP Factory
Input Console
Physical Output
Master Stereo Out Left/Right DS2416 Analog Out Left/Right
and
DS2416 Digital Out Left/Right
Aux Send 1 IOA/IOB Output 1
Aux Send 2 IOA/IOB Output 2
Aux Send 3 IOA/IOB Output 3
Aux Send 4 IOA/IOB Output 4