8.5

Included VST Instruments
Spector
257
Assigning LFO Modulation Destinations
You can assign a modulation destination for an LFO.
PROCEDURE
1. Click in the Mod Dest box for one of the LFOs.
A pop-up menu appears in which all possible modulation destinations are shown. All
Sound parameters as well as most LFO and Envelope parameters are available as
destinations.
2. Select a destination, for example, Cut.
The selected modulation destination is now shown in the list. Beside the destination,
a default value (50) has been set. The value represents the modulation amount.
• You can set positive and negative modulation values by clicking on the value in
the list, typing in a new value, and pressing [Enter].
To enter negative values, type a minus sign followed by the value.
3. Select a suitable LFO Waveform, Speed, Depth, and Sync mode.
You should now hear the Cut parameter being modulated by the LFO.
4. Using the same basic method, you can add any number of modulation
destinations for the LFO.
They are all listed in the Mod Dest box.
• To remove a modulation destination, click on its name in the list and select Off
from the pop-up menu.
Assigning LFO Velocity Destinations
You can also assign velocity-controlled LFO modulation.
PROCEDURE
1. Click in the Vel Dest box for one of the LFOs.
A pop-up menu appears in which all possible velocity destinations are shown.
2. Select a destination.
The selected velocity destination is now shown in the list. Beside the destination, a
default value (50) has been set. The value represents the modulation amount.
• You can set positive and negative values by clicking on the value in the list,
typing in a new value, and pressing [Enter].
To enter negative values, type a minus sign followed by the value.