User manual

Table Of Contents
714
Key commands
Setting up key commands
Setting up macros
A macro is a combination of several functions or commands to be performed in one
go. For example, you can select all events on the selected audio track, remove DC
offset, normalize the events and duplicate them, all with a single command.
Macros are set up in the Key Commands dialog as follows:
1. Click the Show Macros button.
The macro settings are shown in the lower part of the dialog. To hide these from
view, click the button (now renamed Hide Macros) again.
2. Click New Macro.
A new, unnamed macro appears in the Macros list. Name it by typing the desired
name. You can rename a macro at any time by selecting it in the list and typing in a
new name.
3. Make sure that the macro is selected, and use the categories and commands in
the upper half of the dialog to select the first command you want to include in the
macro.
4. Click Add Command.
The selected command appears in the list of commands in the Macros section.
5. Repeat the procedure to add more commands to the macro.
Note that commands are added after the currently selected command in the list.
This allows you to insert commands “in the middle” of an existing macro.
A macro with
three com-
mands
To remove a command from the macro, select it in the Macros list and click Delete.
Similarly, to remove an entire macro, select it in the Macros list and click Delete.
After you have closed the Key Commands dialog, all macros you have created appear
at the bottom of the Edit menu in the Macros submenu, available for instant selection.
You can also assign key commands to macros. All macros you have created appear in
the upper section of the Key Commands dialog under the Macros category – just
select a macro and assign a key command as with any other function.