Remote Control Devices

13
The supported remote control devices
Pan button in the Mixer-Mode section: Fader Set mode
Panning:
• Page 1 – Pan left/right
•Page 2 – Pan front/rear
• Pressing a V-Pot will toggle Monitor for that channel.
High button: Fader Set mode EQ High:
•Page 1 – Gain
• Page 2 – Frequency
•Page 3 – Q
• Page 4 – Enable
• Pressing a V-Pot will bypass EQs for that channel.
HiMid, LowMid, Low button: Fader Set mode EQ Mid-
High, Mid-Low, Low (same functionality as above).
Snd/Ins 1 button: Fader Set mode Send 1:
• Page 1 – Level
• Page 2 – Enable
•Page 3 – Pre/Post
•Page 4 – Bus
• Pressing a V-Pot will bypass sends for that channel.
Snd/Ins 2 to 4 buttons: Fader Set mode Send 2 to Send 4
(same functionality as above). Depending on the Snd/Ins
button status (above Snd/Ins 1 button) Snd/Ins 1 to Snd/
Ins 4 buttons are assigned to Send 1 to Send 4 or Send 5
to Send 8.
EQs button (Channel-Strips section): Selected Channel
mode EQ:
• Page 1 – Gain, Frequency, Q and Enable for the lo band,
Gain, Frequency, Q and Enable for the lo mid band
• Page 2 – Gain, Frequency, Q and Enable for the hi mid band,
Gain, Frequency, Q and Enable for the hi band
• Pressing a V-Pot will bypass EQs.
Inserts/Sends button: Selected Channel mode Sends:
• Page 1 – Level for Send 1 to Send 8
• Page 2 – Enable for Send 1 to Send 8
• Page 3 – Pre/Post for Send 1 to Send 8
• Page 4 – Bus for Send 1 to Send 8
• Pressing a V-Pot will bypass sends.
Dynamics button: Selected Channel mode Routing:
• Page 1 – Output Bus, Monitor, Input Bus, Input Gain, Input
Phase
• Pressing a V-Pot will toggle Monitor.
For a description of the functionalities for the MIDI button:
Selected Channel mode Inserts, Shift+Inserts/Sends but-
ton: Global mode Send Effects, Shift+Dynamics button:
Global mode Master Effects, Shift+MIDI button: Global
mode Instruments, see the chapter “Mackie Control” on
page 17.
The following functions are available:
Instrument button: Selected channel mode Instrument:
• Page 1 – Select instrument
• Page 2-n – Instrument parameter
Roland MCR-8
The Roland MCR-8 can control 16 mixer channels, plus
transport control. The “A/B switch” is used to switch be-
tween controlling channels 1–8 and 9–16. The following
MCR-8 parameters control the equivalent parameters for
each channel strip:
• Fader level, mute, solo and pan.
The following MCR-8 transport controls control the equiv-
alent program functions:
• Play, Stop, Record, Rewind, Fast Forward.
!
Before you can initiate remote control operation, the
MCR-8 “Mode” switch must be set to “4”.
!
The MCR-8 does not support “MIDI feedback”, that
is, the current status of program parameters is not in-
dicated on the MCR-8. Therefore, you only need a
one-way MIDI connection between the MCR-8 and
the program.