Mid-Size Fabric Steam Press Owner’s Guide Guía Del Propietario De La Plancha A Vapor Para Tela De Medio Porte Guide D’utilisation – Presse À Vapeur Pour Tissu De Taille Moyenne MODEL SF-623 MODELO SF-623 MODÉLE SF-623 ENGLISH p. 2 ESPAÑOL p. 14 ENGLISH 1 FRANÇAIS p.
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce risk of fire, electrical shock or injury, the following basic safety precautions should always be followed when using an electrical appliance. WARNING: To reduce the risk of electrical shock, this appliance uses a grounded (three-pronged) plug. This plug will fit in a grounded wall outlet only one way. If the plug does not correctly fit in the outlet, contact a licensed electrician to install a proper outlet.
9. Close supervision is required for any appliance being used near children, pets and plants. Do not leave unit unattended while plugged in. 10. This unit is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the unit by a person responsible for their safety. 11.
Product Information The following features and accessories are included with your steam press. Carefully inspect packaging material as some parts are shipped inside Styrofoam packaging. To obtain possible missing parts, refer to the Consumer Support section on page 10 of this manual.
• The Handle (1) is used to safely lift up and lower the Pressing Plate, and carry the unit. • The Steam Burst Buttons (2) are located on either side of the Handle, and produce a powerful burst of steam when pressed. • The Water Reservoir (3) is the tank in which water is stored for use by the unit. There must be water in the Water Reservoir in order for the unit's steam burst function to work correctly. • The Ironing Board (4) is the padded surface onto which fabric is placed during pressing.
Using Your Mid-Size Fabric Steam Press FILLING WATER RESERVOIR 1. 2. 3. 4. Place Mid-Size Fabric Steam Press on a flat, level surface. Turn Locking Knob to “Unlock” position to unlock Pressing Plate. Lift up Pressing Plate using Handle. It will automatically stay in lifted position. Pull Water Reservoir out. Note that Water Reservoir cannot be completely removed from unit; do not attempt to force it free. 5. Using Measuring Cup (included), fill Water Reservoir up to the 150ml (5.07 oz) line with water.
STEAM BURST 1. Hold Pressing Plate approximately 3 in. (75 mm.) above Ironing Board. 2. Press Steam Burst Button to release a burst of steam onto fabric for 2-3 seconds. 3. Lower Pressing Plate onto fabric for 8-10 seconds, then raise once again. Note: If press is left on fabric for more than 10 seconds, it could result in damage to fabric. 4. Repeat steps 1-3 above until fabric is smooth and wrinkle-free. PRESSING AND STEAMING TIPS Pressing Shirts And Blouses 1.
Storage & Care AUTO SHUT-OFF The Auto Shut-Off feature deactivates electrical power to the heater when the Pressing Plate has been left in closed position against the Ironing Board. The Pressing Indicator Light (Orange) and Steam Burst Ready Indicator Light (Orange) does not illuminate. Heater functionality is restored when the Pressing Plate is lifted back up. IMPORTANT: Auto Shut-Off does not mean that power to the unit is totally cut off.
Troubleshooting PROBLEM POSSIBLE CAUSE SOLUTION Unit fails to heat up and steam. Power Indicator Light does not illuminate. Unit is not plugged in. Plug into electrical outlet. Household Circuit Breaker/ Ground Fault Interrupter has tripped or blown a fuse. Reset Circuit Breaker/Ground Fault Interrupter, or replace fuse. If you need assistance, contact a licensed electrician. Unit fails to heat up and steam. Power Indicator Light does illuminate. Auto Shut-Off has engaged.
Product Support CONSUMER SERVICES For problems with your Fabric Steam Press, please refer to the troubleshooting guide located on Page 9 of this manual. Additional inquiries should be directed to our consumer support services through our Web site, www.steamfast.com. If you do not have internet access, you may also contact our Consumer Service Department by telephone, at 1-800-711-6617.
ACCESSORIES & PARTS When ordering accessories and parts for your Fabric Steam Press, you may refer to the part numbers below. Replacement parts may be ordered through our Web site: www.steamfast.com You may also contact Consumer Service directly: consumerservice@steamfast.
Warranty Information 1-YEAR LIMITED WARRANTY What is covered Steamfast, a division of Vornado Air, LLC (“Steamfast”).
• THIS WARRANTY GIVES BUYER SPECIFIC LEGAL RIGHTS. BUYER MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE-TO-STATE. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, AND SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO BUYER. How do you register the Warranty Buyer must complete an application to register this Warranty within sixty (60) days following date of purchase.
review this product online evalúe este producto en línea évaluer ce produit en ligne www.steamfast.com/reviews Steamfast 1-800-711-6617 415 East 13th Street, Andover, KS 67002 www.steamfast.com consumerservice@steamfast.
