User Manual

14
15
PIC. 11
DRAIN TAP
Pic. 11
After use open the drain tap to drain excess air and any
moisture. The excess air will also help purge the moisture.
Leave the drain tap open when air compressor is not in use,
so any moisture can continue to drain
To open the drain tap pull the lever down to vertical.
To seal the drain tap push the lever up to horizontal.
NOTE: Remember to seal the drain tap before starting
the compressor.
Drain Tap Sealed
OR
To close and seal push lever up Right or left
Drain tap opened un-sealed
AIR FITTING
Pic. 10
This air compressor is fitted with a ‘Nitto style’
(female) socket.
1. Push in the ‘Nitto style’ male plug (not included).
2. Fully and completely push the ‘Nitto style’ male plug
(not included) into the ‘Nitto style’ female socket until
it clicks and the collar locates forward.
To remove
1. Push collar down and remove male fitting,
collar will stay retracted.
NOTE: For ease of connection and disconnection use
regulator to reduce outlet pressure to 0PSI.
This compressor has a maximum pressure of 145PSI
(10 bar).
Always regulate the outlet air pressure to match your
air tool.
Different air tools require different operating pressures.
Always check with the air tool manufacturer if unsure.
PIC. 10
Outlet
pressure
gauge
Nitto style
outlet socket
(Air Outlet)
Tank
pressure
gauge