Assembly Instruction

NOTE: Your furniture may have different design features than those shown in the drawing.
A-1028
WRENCH
1. PREPARE FOR ASSEMBLY:
Turn the TOP ASSEMBLY "upside down" on a smooth surface such as a Carpeted Floor.
Position two POSTS so that the INSERTS in the POSTS line up with
the Holes in the BLOCKS on the TOP ASSEMBLY. Insert WASHER
(C), LOCK WASHER (B), and BOLTS (A) into the Holes in BLOCKS
and Hand Tighten Loosely to the POSTS.
Position SHELF between POSTS so that the Holes in the SHELF line
up with the NOTCHES in the POSTS. Insert WASHER (C), LOCK
WASHER (B), and BOLT (A) into the Holes in SHELF and Tighten
with WRENCH (D).
Position final Two POSTS so that the INSERTS in the POSTS line up
with the Holes in BLOCKS on the TOP ASSEMBLY. Insert WASHER
(C), LOCK WASHER (B), and BOLTS (A) into the Holes in BLOCKS
and Tighten to the POSTS with WRENCH (D).
Insert final Two WASHERS (C), LOCK WASHERS (B), and BOLTS
(A) into Holes in the SHELF and Tighten to the POSTS with
WRENCH (D).
Finish Tightening the First Two POSTS with WRENCH (D).
After Table is Assembled, CAREFULLY turn the TABLE upright and
Position as desired.
2. ATTACH THE POSTS AND SHELF:
3. ADJUSTABLE GLIDES:
Adjustable Glides are located Bottom of the Four POST, as shown in the drawing. Turn Adjustable Glide CLOCKWISE to lower case; COUNTERCLOCKWISE to raise.
CAREFULLY READ AND
UNDERSTAND ALL
INSTRUCTIONS BEFORE
PROCEEDING!
CAUTION:
(2) OR MORE PERSONS
RECOMMENDED FOR
ASSEMBLY!
WRENCH