Use and Care Manual

ASSEMBLY INSTRUCTIONS
7
ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE
inTONE® REBOUNDER. FAILURE TO USE TWO OR MORE STRONG PEOPLE MAY
ALLOW THE RAILS TO SPRING BACK INTO THE FOLDED POSITION AND STRIKE
SOMEONE WHICH CAN CAUSE SERIOUS BODILY INJURY OR DEATH.
Keep ngers away from the ends of the rails in the hinge area when unfolding the
inTONE® Rebounder. Serious injury can occur if ngers are caught between the ends
of the RAILS.
STOP!
Hold RAILS(3, 4) and push down on RAILS(1, 2) to unfold the inTONE® Rebounder to the at position.
The RAILS(1, 4) and RAILS(2, 3) should snap together and be locked by the SECURE PINS(10) when
you reach the at position. Refer to illustration 2.
STEP 2
NOTE: Make sure the SECURE PINS(10) are inserted into the ends of RAILS(1, 2) and properly secured
by the Wire Ring. Both ends of the SECURE PINS(10) should have approximately 1/8 inch between
the RAILS(1, 2) and the Wire Ring. Refer to illustration 2.
2. 3.
A. First step,
install the Safety Pad(6) on
to this Threaded Connector.
B. Second Step,
install the Safety
Pad(6) on to
this Threaded
Connector.
Hazard label on trampoline surface reads as follows:
!
WARNING!
PREVENT serious INJURY or DEATH.
Rails can SPRING back and STRIKE someone.
ALWAYS fold and unfold carefully with TWO or
more STRONG people.
Do NOT remove this tag.
!
WARNING
STEP 3
Slide the SAFETY PAD(6) over the rail frame. Make sure the holes in SAFETY PAD(6) t over the threaded
connectors properly. Refer to illustration 3.
HINT : Install one hole over a threaded connector. The next hole installed should be on the connector on
the opposite side of the trampoline.
CAUTION: The SAFETY PAD(6) must be securely attached to the rail frame in the correct position. All six
(6) holes in the SAFETY PAD(6) must t over a threaded connector on the rail frame as shown
in illustration 4 on the following page. The SAFETY PAD(6) must also cover the elastic bands
on the MAT(5) as shown in illustration 5 on the following page.