User manual
Table Of Contents
Press [MENU] repeatedly until the display shows ‘DMX Address’ . Press [ENTER]. Now you can set
the number of the rst DMX channel to be used by the device (DMX address). Use the [Up] and
[Down] buttons to select a value between 1 and 512.
When the display shows the desired value press [ENTER] to return to the main menu.
Make sure that this number matches the conguration of your DMX controller. The following
table shows the highest possible DMX address for the various DMX modes.
Mode Highest possible DMX address
5-channel 508
13-channel 500
Press [MENU] repeatedly until the display shows ‘Channel Mode’ . Press [ENTER]. Now use the
[Up] and [Down] buttons to select one of the following DMX operating modes: 5-channel ( ‘5 Ch
Mode’ ) or 13-channel ( ‘13 Ch Mode’ ). This setting is only relevant when the device is controlled
via DMX.
When the display shows the desired value, press [ENTER] to return to the main menu or [MENU]
for at least two seconds to switch immediately in operation mode „DMX“.
DMX address
Operating mode „DMX“
Operating
xBrick Full-Colour 16×3W
23
LED Floodlight