User manual

Press [M]. Press one of the arrow buttons repeatedly until the display shows ‘DMX’ . Press [OK].

Press one of the arrow buttons repeatedly until the display shows ‘MODE’ . Press [OK]. Now use

the arrow buttons to select one of the following DMX modes:

n ‘1CH’ (one channel)

This setting is only relevant if the device is being controlled via DMX. When the display shows

the desired value, press [OK]to conrm the selection and then [M]to return to the parent menu.

To return to the parent menu without making changes, press [M].

Press [M]. Press one of the arrow buttons repeatedly until the display shows ‘DMX’ . Press [OK].

Press one of the arrow buttons repeatedly until the display shows ‘ADDR’ . Press [OK]. Now you

can set the number of the rst DMX channel used by the device (DMX address). Use the arrow

buttons to select a value between 1 and 512. (Display shows ‘A001’ … ‘A512’ ).

When the display shows the desired value, press [OK]to conrm the selection and then [M]to

return to the parent menu. To return to the parent menu without making changes, press [M].

Make sure this number matches the conguration of your DMX controller.

DMX mode

DMX address

Operating

PAR