User manual

Press [M]. Press one of the arrow buttons repeatedly until the display shows ‘DMX’ . Press [OK].

Now you can set the number of the rst DMX channel to be used by the device (DMX address).

Use the arrow buttons to select a value between 1 and 512 (display shows ‘A001’ … ‘A512’ ).

When the display shows the desired value press [OK] to conrm the selection and then [M] to

return to the parent menu. To return to the parent menu without making changes, press [M].

Make sure that this number matches the conguration of your DMX controller. For the 5-

channel DMX mode, the highest possible start address is 508.

Press [M]. Press one of the arrow buttons repeatedly until the display shows ‘TEST’ . Press [OK].

Press one of the arrow buttons repeatedly until the display shows ‘COLD’ , ‘STRO’ or ‘WARM’ .

Press [OK].

In this stand-alone mode, you can change the speed of the strobe eect in the range of 0 (no

speed) to 24 (high speed) and the dimmer settings for cold and warm white (range 0 to 255).

DMX address

Manual test

Operating

LED PAR